Subscribe to Our Youtube Channel
Related Manuals for Hall Technologies HT-DSCV3
Summary of Contents for Hall Technologies HT-DSCV3
- Page 1 Hall Technologies • 1234 Lakeshore Dr Suite #150 Coppell, TX 75019 • halltechav.com HT-DSCV3 USB 3.2 Extender Family USER MANUAL March 21, 2025 Hall Technologies March 21, 2025 Page 1 of 13...
-
Page 2: Important Safety Instructions
8. Protect the power cord from being walked on or pinched particularly at plugs. 9. Only use attachments / accessories specified by the manufacturer. Refer all servicing to qualified service personnel. Hall Technologies March 21, 2025 Page 2 of 13... -
Page 3: Table Of Contents
Overview ............................4 Features............................4 Package Contents ............................5 Connectors & Indicators ..........................6 HT-DSCV3-TX Front and Rear Panel ....................6 HT-DSCV3-TX-WP Front and Rear Panel ..................7 HT-DSCV3-RX Front and Rear Panel ....................8 HT-DSCV3-RX-WP Front and Rear Panel ..................9 HT-DSCV3-RX-V2 Front and Rear Panel .................. -
Page 4: Introduction
(TX or RX). The transmitter’s built-in PSE module, when connected to local power, provides 90W charging to the host device via USB-C. Using the HT-DSCV3-RX-V2 model, video from a PC can be received and displayed on two separate displays/monitors using only a USB-C connection from the laptop into a transmitter. -
Page 5: Package Contents
Package Contents HT-DSCV3-TX 1x Extender Transmitter Unit 1x 3-Pin Phoenix Male Connector 2x L-brackets with Screws 4x Rubber Feet HT-DSCV3-TX-WP 1x Extender Transmitter Wall Plate 1x Cover Plate w/ Screws 1x 4-Pin Phoenix Male Connector ... -
Page 6: Connectors & Indicators
Power LED indicates the power supply is 5V DC. 54V power supply connection, connected at either TX or RX side. (Included with HT- DSCV3-RX and HT-DSCV3-RX-V2 models only.) NOTE: for source charging, connect power supply locally at HT-DSCV3-TX USB LED indicates a host PC is properly connected. HOST USB 3.2 Type-C 5G interface for the host connection. -
Page 7: Ht-Dscv3-Tx-Wp Front And Rear Panel
12V local power and RS-232 pass-through from TX to RX or from RX to TX. RS232 / PWR NOTE: 12V power is only needed when connecting HT-DSCV3-TX-WP and HT-DSCV3-RX- WP in a chain. Otherwise, power will be POH from HT-DSCV3-RX or HT-DSCV3-RX-V2. HDBT HDBaseT output, connected to the RX input via Cat5e/6/7 cable. -
Page 8: Ht-Dscv3-Rx Front And Rear Panel
Power LED indicates the power supply is 5V DC. 54V power supply connection, connected at either TX or RX side. NOTE: for source charging, connect power supply at HT-DSCV3-TX. Devices, Type-A USB 3.2 Type-C 5G interface for device connections, providing 1A power. -
Page 9: Ht-Dscv3-Rx-Wp Front And Rear Panel
12V local power and RS-232 pass-through from TX to RX or from RX to TX. RS232 / PWR NOTE: 12V power is only needed when connecting HT-DSCV3-TX-WP and HT-DSCV3-RX- WP in a chain. Otherwise, power will be POH from HT-DSCV3-TX. -
Page 10: Ht-Dscv3-Rx-V2 Front And Rear Panel
Two individual HDMI video outputs used to connect to two different displays. HDMI OUT NOTE: When a PC is connected to the HT-DSCV3-TX (or -WP), the PC can be set to extend in project mode, allowing for 2 additional displays to be extended to. -
Page 11: Specifications
Technical USB Standard USB 3.2 Gen 1x1 Data Rate Up to 5 Gbit/s Transmission Distance 90m over Cat6A/7 HT-DSCV3-TX 1 x USB 3.2 Type-C, Host Inputs 1 x 3-Pin Phoenix, RS-232 Outputs 1 x RJ-45, HDBT Firmware 1 x USB 2.0 Type-C Dimensions 5.5”... - Page 12 HT-DSCV3-RX-V2 Inputs 1 x RJ-45, HDBT 2 X USB 3.2 Type-A, Devices 1 x USB 3.2 Type-C, Devices Outputs 2 x HDMI Outputs 1 x 3.5mm Line Audio Output 1 x 3-Pin Phoenix, RS-232 Resolution 4k@30Hz, each output Firmware 1 x USB 2.0 Type-C Dimensions 7.9”...
- Page 13 © Copyright 2024. Hall Technologies All rights reserved. 1234 Lakeshore Drive, Coppell, TX 75019 halltechav.com / support@halltechav.com (714)641-6607 Hall Technologies March 21, 2025 Page 13 of 13...
Need help?
Do you have a question about the HT-DSCV3 and is the answer not in the manual?
Questions and answers