1 Important General information safety To avoid damage or malfunction: instructions • Do not expose headphones to excessive heat. • Do not drop your headphones. • Headphones shall not be exposed to dripping or splashing. (Refer to the IP rating of specific product) Hearing safety •...
Page 3
2 Your Ear-hook Overview of your Ear- headphones hook headphones Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/support. With these Philips Ear-hook headphones you can: •...
3 Get started 4 Use your headphones How to wear Connect the headphone Check left or right orientation of the to your device headphones. Adjust the hook to properly angle. Connect headphone to your device via 3.5 mm connector. Hook headphones onto your ears. Call control Pick up Single press...
5 Technical data 6 Notice Disposal of your old Sound product • Magnet type: Neodymium • Frequency response: 20 - 20,000 Hz • Sensitivity: 96 dB • Speaker diameter: 15 mm Your product is designed and • Impedance: 16 Ohm manufactured with high quality materials and components which can be recycled and reused.
Page 6
MMD Hong Kong Holding Limited. All rights reserved. Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.
Need help?
Do you have a question about the 1000 Series and is the answer not in the manual?
Questions and answers