Page 1
FlexBreeze Pro Mist Fan FA300UK Series OWNER’S GUIDE...
Page 2
12. Prior to cleaning or other maintenance, the appliance must be unplugged from the electrical outlet. 2. Compatible battery type is CR2025. 13. Only use Shark branded accessories. 3. The nominal battery voltage is 3V. 14. Do not use if appliance is not working as it should, or has been dropped, damaged, left outdoors for extended periods of time in WARNING: Not suitable for use with solid-state speed controls.
2 hours of ingestion. Seek medical attention immediately. • Not want to eat solid food / be unable to eat solid food. Shark FA300UK Series Product Information According to: Commission Regulation (EU) 206/2012 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to eco-design requirements for air conditioners and comfort fans.
CAR CHARGER - SOLD SEPARATELY IMPORTANT SAFETY INSTRUCTIONS INSTRUCTIONS FOR USE: READ ALL INSTRUCTIONS BEFORE USE Firmly insert the car charger plug into a 12-volt outlet in SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for battery charger model your vehicle.
WHAT’S INCLUDED Base Fan Head Water Tank (already assembled) Pole Fan Cover Misting Hose Hex Key Bolt Remote Charger Note: Images enlarged for clarity. (reference image only) ACCESSORIES AVAILABLE FOR PURCHASE Different fan models come with different accessories. To purchase an accessory that was not included, go to sharkclean.co.uk. Car Charger Fan Cover Travel Bag...
SETTING UP YOUR REMOTE ASSEMBLING YOUR FAN COIN CELL BATTERY REMOTE MODELS 1. Remove the battery saver paper from the remote. AAA BATTERY REMOTE MODELS 1. Slide the battery cover off the rear side of the remote. Note: Images enlarged for clarity.
FEATURES CORDLESS OUTDOORS OUTDOOR MISTING NATURALBREEZE This is a 2-in-1 fan that can be used This fan can be enjoyed indoors or Activate one of the NaturalBreeze Integrated misting enabled through with or without the cord. outdoors. DO NOT CHARGE OR USE modes to simulate wind conditions.
VERTICAL TILT To adjust the vertical height of the fan head, use the handle to manually tilt the head up or down. The fan has a vertical range of 55° degrees. Fan head tilted UP Fan head tilted DOWN HOW TO CARRY YOUR FAN •...
Page 9
DISASSEMBLY Charging port labeled with With the misting Ensure your fan is Gently remove To detach the To detach the misting hose other end of the hose fully removed, unplugged before the Misting Hose from the Fan misting hose press the Lift-Away disassembly.
SETTINGS • To preserve battery life, the fan will enter IDLE mode if left unplugged and powered off for 24 hours. In IDLE mode, the remote cannot be used to turn on the fan. To turn off IDLE mode and turn on the power, press the power button on top of the fan head.
FAN SPEEDS Changing the FAN SPEED will increase or decrease the airflow of the fan. To change the speed, press on the fan head to cycle through the different speeds. With the REMOTE, press the left and right arrows to change speeds. The LEFT ARROW will DECREASE the speed of the fan and the RIGHT ARROW will INCREASE the speed of the fan.
Page 12
TIMER TIMER If you don’t want to leave your fan constantly on, but don’t want to think about it, use the timer setting (remote only). You can choose between timer settings 1-5 hours. To activate timer, press on your remote. LED lights will appear and blink to indicate how many hours the timer is set for. LEDs will switch off after 20 seconds.
Page 13
NATURALBREEZE MODES Turn on either of the NaturalBreeze modes to simulate natural wind conditions. To activate STRONG NaturalBreeze, press the icon on the REMOTE or press the icon on the fan head until the corresponding LEDs are displayed on the unit (see table below for LED patterns). To transition from STRONG NaturalBreeze to GENTLE NaturalBreeze press the icon on the REMOTE again, or press the...
Page 14
OSCILLATION Choose one of the 3 oscillation angles. To change the oscillation settings, press the Oscillation icon on the REMOTE or the fan head. To turn off oscillation, press the same Oscillation icon on the REMOTE or the fan head until no LEDs are illuminated. DISPLAY ANGLE BEST FOR...
Page 15
OUTDOOR MISTING This misting feature is suitable for OUTDOOR USE ONLY. Choose between 3 misting settings to best suit your needs. To change the misting settings, press the Misting icon on the remote or the fan head to cycle through the settings. To turn off misting, press the Misting icon on the remote or the fan head until no LEDs are illuminated.
The second LED indicator and This error state indicates an issue with the voltage of the Battery LED (in amber) the charger. Please be sure to only use the provided Shark® charging cable and power supply. are flashing. What is wrong? Why do I have to activate Lock mode The fan must be in Lock mode when any maintenance is performed.
MAINTENANCE We recommend cleaning your water tank and misting hose with unscented soap and water every 3 months or as needed. Ensure you empty and dry the water tank and misting hose after every use. We recommend cleaning the misting nozzles every 12 months or as needed. Using harder water will require more frequent cleaning. To clean the misting nozzles: 1.
Page 18
HARDWARE SPECS 2.52mm Grille Screw 16mm For securing the grille to the fan Drive Type Phillips Thread Size / Pitch M3 x 0.5mm Length 16mm No.1 M3x0.5mm Screwdriver For driving the screw Drive Type Phillips Size No. 1 85mm Bolt 24mm For securing base to pole Drive Type...
Page 19
When you register your guarantee, you will get an extra year of cover. We’ll also have your details to hand if we ever need to get in touch. If you further agree to receive communications from us, you can also receive tips and advice on how to get the best out of your Shark Fan appliance and hear the latest news about new Shark technology and launches.
Need help?
Do you have a question about the FA300UK Series and is the answer not in the manual?
Questions and answers