When your remote battery needs to be replaced, dispose of it or 14. Only use Shark branded accessories. recycle it in accordance with local ordinances or regulations. In some areas, it is 15. Do not use if appliance is not working as it should, has been damaged, or illegal to place spent lithium batteries in the trash or in a municipal solid waste dropped into water.
CAR CHARGER IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS INSTRUCTIONS FOR USE: READ ALL INSTRUCTIONS BEFORE USE READ ALL INSTRUCTIONS BEFORE USE Firmly insert the car charger plug into a 12-volt outlet SAVE THESE INSTRUCTIONS. This manual contains important safety SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for battery charger model FA20XCAR and operating instructions for battery charger model FA20XCAR in your vehicle.
WHAT’S INCLUDED Base Fan Head Water Tank (already assembled) Pole Misting Hose Allen Wrench Bolt Remote Charger Note: Images enlarged for clarity. (reference image only) ACCESSORIES AVAILABLE FOR PURCHASE Different fan models come with different accessories. To purchase an accessory that was not included, go to sharkclean.com. Car Charger Fan Cover Travel Bag...
ASSEMBLING YOUR FAN Note: Images enlarged for clarity. Upper pole Charging port labeled with Align yellow arrow on The upper pole Rotate clockwise to bottom of pole with has wider end. tighten the bolt. yellow dot on base 1. Align and insert Align the yellow Turn the base on its CAUTION: finger...
TABLETOP MODE To convert the fan to portable, tabletop mode: Spread out the four support Connect the misting hose to the water tank To detach the fan head from legs until they are fully and fan head while in tabletop mode for the pole, press the Lift-Away extended, then place the misting on the go.
Page 8
DISASSEMBLY If grill screw, bolt, or Allen wrench have been lost, see Hardware Specs section for information on how to replace any hardware. Charging port labeled with With the misting Ensure your fan is Gently remove To detach the To detach the the Misting Hose misting hose other end of the...
SETTINGS • Before first use, pull out the plastic tab from the battery compartment of the remote control. • To preserve battery life, the fan will enter IDLE mode if left unplugged and powered off for 24 hours. In IDLE mode, the remote cannot be used to turn on the fan.
FAN SPEEDS Changing the FAN SPEED will increase or decrease the airflow of the fan. The number of fan speeds varies by model, see chart below for more details. To change the speed, press on the fan head to cycle through the different speeds. With the REMOTE, press the left and right arrows to change speeds.
Page 11
BREEZEBOOST™ MODE Turn on BreezeBoost for maximum-power airflow. When operating cordlessly, BreezeBoost will automatically turn off after 20 minutes to save battery. BreezeBoost will run indefinitely when the fan is plugged in. To activate BreezeBoost, press the icon on the REMOTE or press the icon on the fan head 5 times.
Page 12
NATURALBREEZE MODES Turn on either of the NaturalBreeze modes to simulate natural wind conditions. To activate STRONG NaturalBreeze, press the icon on the REMOTE or press the icon on the fan head until the corresponding LEDs are displayed on the unit (see table below for LED patterns). To transition from STRONG NaturalBreeze to GENTLE NaturalBreeze press the icon on the REMOTE again, or press the...
Page 13
OSCILLATION Choose one of the 3 oscillation angles. To change the oscillation settings, press the Oscillation icon on the REMOTE or the fan head. To turn off oscillation, press the same Oscillation icon on the REMOTE or the fan head until no LEDs are illuminated. DISPLAY ANGLE BEST FOR...
Page 14
OUTDOOR MISTING The misting feature is suitable for OUTDOOR USE ONLY. Choose between 3 misting settings to best suit your needs. To change the misting settings, press the Misting icon on the remote or the fan head to cycle through the settings. To turn off misting, press the Misting icon on the remote or the fan head until no LEDs are illuminated.
The second LED indicator and This error state indicates an issue with the voltage of the charger. the Battery LED (in amber) Please be sure to only use the provided Shark™ charging cable and power supply. are flashing. What is wrong? Why do I have to activate Lock mode The fan must be in Lock mode when any maintenance is performed.
MAINTENANCE • We recommend cleaning the water tank and misting hose with unscented soap and water every 3 months or as needed. Ensure you empty and dry the water tank and misting hose after every use. • We recommend cleaning the misting nozzles every 12 months or as needed. Using harder water will require more frequent cleaning.
HARDWARE SPECS 16mm Grill Screw For securing the grill to the fan Drive Type Phillips Thread Size / Pitch M3 x 0.5mm Length 16mm No.1 Screwdriver For driving the screw Drive Type Phillips Size No. 1 85mm Bolt 24mm For securing base to pole Drive Type Thread Size / Pitch M6 x 1mm...
Need help?
Do you have a question about the FlexBreeze Pro Mist FA300 Series and is the answer not in the manual?
Questions and answers
how do you pack the shark breeze travel bag