Pyle PLPTS2, PLPTS3, PLPTS4 Manual

Kit Contents

	Device Resting Plate
	Extension Arm
	Folding Tripod Base
	Mounting Clamps
	Extension Arm Fitting Insert
	Wing Nuts
	Washers
	Plate Bolts

Setting Up

	The metal mounting clamps slide onto both ends of the extension arm. Each side is fitted with rubber grips that the clamps use for holding support. Be sure as to, at least partially, slide the metal mounting clamps to lay over the rubber grips. Use the dual clamp-style knobs on both sides on each of the mounting clamps to secure the angle and placement of the device resting plate.
	Use the included hardware to secure the device resting plate with the metal mounting clamps. The holes in the mounting clamp brackets should align with the holes protruding through the base plate. Be sure to use a washer between the wing nut and the metal mounting clamp when securing.
	The plate bolts are to be inserted from the top of the unit, going downward through the device resting plate, and out of the other end to meet the metal mounting brackets. The metal mounting bracket clamps can be adjusted or loosened accordingly to allow for angle/tilt adjustment.
	Make sure to use the extension arm fitting insert and place it inside the folding tripod base where the tightening nut and screw is located -- there is a notch slot that will accept this insert. This will ensure when height adjustments are made the unit will securely hold your device at the desired height. Please note, there is a small button on the extension arm fitting insert, be sure when placing into the folding tripod base slot -- that this button is underneath the nut that is inside the holding base's notch slot.
	Slide the assembled extension arm and device resting plate into the assembled folding tripod base with the inserted extension arm fitting insert. The top clamp style knob allow for height adjustment by raising or lowering the unit's extension arm. The lower clamp style knob allows for securing the stand's stability when the tripod legs are extended. The unit also features a safety pin that acts as a backup for the stand's height adjustment safety.

PyleUSA.com

Documents / Resources

References

• Pyle USA Electronics | Home Audio | Car Audio & More

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Pyle PLPTS2, PLPTS3, PLPTS4 Manual