Pyle PLPTS25 User Manual

PREPARATION:
Remove the following parts from the box and identify all the parts:
(2) Upper Supports
ASSEMBLING INSTRUCTIONS
1. Start by removing the end caps from
the two stabilizer rods.
2. Assemble the left/right support brackets.
Take one side of the upper supports and
match it with the corresponding side
lower support (the lower supports
feature an anti-slip grip pad on the
bottom) - Figure A.
Align the mounting holes at the desired
height and position the Screw Knobs
through the supports (ensure not to
over-tighten). -Figure B.
NOTE:The Stabilizer Bars MUST be
positioned at least 2 holes apart.
3. Repeat steps 1 & 2 above to assemble
the other side of the stand's support
bracket aligning the correct heights
of the stabilizer rods.
www.PyleUSA.com
PLPTS25
Laptop Computer Stand For DJ
(2) Lower Supports
(2) Stabilizer Rods
(4) Screw Knobs
Figure A
Figure B