Haworth PREMISE 263-258 Installation Instructions

PREMISE™ CORNER UNIT
Installation Instructions
(For Units Manufactured after 5/98)
Tools Required
Cross-recess (Phillips) screw driver
Level
Power Driver (optional)
Hex head driver
Corner Unit Assembly
1. Place the corner top on a carpeted or padded
clean area of the floor with the holes facing up.
2. Attach brackets to end panels using two (2) #10
x 1-1/4" flat head screws per bracket (Fig. 1).
NOTE: When another unit will be adjoining the
opposite side of the end panel, center the bracket
on the end panel and use center two holes when
attaching bracket to the end panel (Fig. 2).
3. Align bracket holes in the end panel with pre-
drilled holes on each end of corner top. Attach
each end panel using four (4) #10 x 1" truss
head screws (Fig. 3).
4. Place outer leg, (glide facing up and solid wall
toward outer corner) onto corner top, aligning
holes in corner leg bracket with pre-drilled holes
located near outer corner of top. Attach outer
corner leg to top using four (4) #10 x 1" pan
head screws (Fig. 4).
#10 X 1"
TRUSS HEAD
SCREW (4)
FIG.3
CUSTOMER SERVICE PHONE: 1-800-426-8562
E.C.O. No: 263-258
#10 X 1-1/4"
FLAT HEAD
SCREWS
FIG.1
FIG.2
#10 X 1"
PAN HEAD
SCREW (3)
FIG.4
Page: 1 of 2 Part No: 7021-7260
5. Slide the inner corner leg down into outer
corner leg. Align holes in inner corner leg with
holes in tab of outer corner leg nearest
underside of corner top. Fasten corner legs
together using four (4) #10 x 3/8" screws, two
(2) at each end (Figs. 5, 6).
6. Position modesty panel between end panel
and the corner leg assembly, aligning slots in
the sides of each modesty panel with holes in
corner leg assembly, Use two (2) #10 x 3/4"
pan head screws to attached each modesty
panel to end panel. Use two (2) #10 x 3/8"
pan head screws to attach each modesty
panel to the corner leg assembly. Screw(s)
must be aligned through holes in both the
inner and outer corner leg. (Fig. 7). Repeat
on other side.
7. Turn unit over and attach necessary adjacent
unit(s) and level.
#10 X 3/8"
PAN HEAD
SCREW
FIG. 7
Rev. A
INNER LEG
#10 X 3/8" SCREW
(2) AT EACH END
FIG. 5
FIG. 6
MODESTY
PANEL(S)
#10 X 3/4"
PAN HEAD
SCREW
ALIGN HOLES IN
INNER AND OUTER
CORNER LEGS