Sharp SH-920 Instruction Manual page 19

(B) STARTING UP THE MACHINE
Take away the clamping plates
1.
1.1 Take away the clamping plates which clamp:
(A) the table with saddle, and
(B) the saddle with machine bases.
1.2 Do not turn the hand wheel before the clamping plates are removed.
Turn the table longitudinal control lever L1 to its valve closing position
2.
(Fig.3). Note: L1 correspond to the handle for flow control valve 10a of
Fig.20.
Turn the directional arm L2 to its neutral position (L2 in Fig.3), correspond
3.
to the arm for pilot valve 10b of Fig.20.
Table dogs T1, T2 (Fig.3) must be well fixed at its proper position (not
4.
exceed its maximum stroke) in table slot.
Fig. 3 Table Dogs
P.19 OF 70