Care And Maintenance - Britax BODYGUARD User Manual

Care and Maintenance

Cover Removal
TIP: Use a blunt wooden rod (pencil,
chopstick, etc.) to assist with
untucking the cover from the hooks
on the shell.
1 To remove base cover:
Unfasten buttons (2x) on
•
bottom front edge of base ( Fig.
A-1 ).
Unfasten hook and loop strap
•
from rear of base ( Fig. A-2 ).
2 To remove backrest cover:
Unhook elastic loops (2x) from
•
attachment points on upper
rear of backrest ( Fig. A-3 ).
Unhook elastic loops (2x) from
•
attachment points on lower
rear of backrest ( Fig. A-4 ).
Untuck cover from hooks (4x)
•
on sides of backrest ( Fig. A-5 ).
3 To remove headrest cover:
Unhook elastic loops (2x) from attachment points on beltguides
•
( Fig. A-6 ).
Unhook elastic loops (2x) from attachment points on lower rear
•
of backrest ( Fig. A-4 ).
Untuck cover from hooks (2x) at top of headrest ( Fig. A-7 ).
•
14
7
6
3
5
4
2
1
A
Refitting the Cover
TIP: Use a blunt wooden rod (pencil, chopstick, etc.) to assist with
tucking the cover under the hooks on the shell.
1 To refit headrest cover, place cover over headrest, then:
Hook elastic loops (2x) to attachment point on beltguides ( Fig.
•
A-6 ).
Hook elastic loops (2x) to attachment points on lower rear of
•
backrest ( Fig. A-4 ).
Tuck cover under hooks (2x) at top of headrest ( Fig. A-7 ).
•
2 To refit backrest cover, place cover over backrest, then:
Hook elastic loops (2x) to attachment points on upper rear of
•
backrest ( Fig. A-3 ).
Hook elastic loops (2x) to attachment points on lower rear of
•
backrest ( Fig. A-4 ).
Tuck cover under hooks (4x) on sides of backrest ( Fig. A-5 ).
•
To refit base cover, place cover over base, then:
3
Fasten buttons (2x) on bottom front edge of base ( Fig. A-1 ).
•
Fasten hook and loop strap around lower backrest ( Fig. A-2 ).
•
Cleaning the Cover
HAND WASH, using cold water and mild soap.
LINE DRY, to prevent cover from shrinking.
Bleach, machine wash, or machine dry.
DO NOT:
Cleaning the Shell
SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY
DO NOT: Use solvents, abrasive cleaners, or disassemble
booster in any way, except as instructed.
Care and Maintenance
15