Subscribe to Our Youtube Channel
Related Manuals for Knuth HB 210 A
Summary of Contents for Knuth HB 210 A
- Page 1 Machine Tools OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS HB 210 A, HB 250 A Part No.: 152850, 152796 HB 210 A, HB 250 A...
- Page 2 Control the plug and the cable regular and in case of damage let it repair by the after sales service. Please control also the extension cable. Never use the machine without Protection Earth. Unplug the machine HB 210 A, HB 250 A...
- Page 3 Leaving the machine Never leave the machine while it is running. Alcohol, medicaments, drugs Never use the machine under influence of alcohol, medicaments or drugs Danger of fire Don’t use highly inflammable fluids. HB 210 A, HB 250 A...
- Page 4 WORKING WITH THIS MACHINE ................7 INCLINED CUTS ......................9 REPLACEMENT OF THE BLADE ................9 MAINTENANCE ......................9 ADJUSTMENT OF BLADE GUIDE BEARINGS ............. 10 CIRCUIT DIAGRAM ....................11 SPARE PARTS ....................... 12 HB 210 A, HB 250 A...
-
Page 5: Specifications
3. Transportation after unpacking, please use heavy duty fiber belt to lift up the machine. Always keep proper footing and balance while moving this machine. As this machine weights 157kgs it is recommended that the machine be transported with help of lifting jack. HB 210 A, HB 250 A... - Page 6 Machine Tools OPERATING INSTRUCTIONS HB 210 A, HB 250 A...
-
Page 7: Installation
3 WORKING WITH THIS MACHINE 1. Position the vice about 4 mm from the workpiece by operating the vice handwheel. 2. Clamp the workpiece in the vice completely by turning the vice lever. HB 210 A, HB 250 A... - Page 8 10. If the sawblade has reached its full speed, you can push down the saw bow. Please be careful! Feed the bow slowly and with normal force. High force will damage the sawblade and the saw. (At the type HB 210 A the downfeed can be adjusted at the screw of the hydraulic downfeed unit.)
-
Page 9: Maintenance
1. Lubricate the slide, the vice, and the blade guide periodically. Clean the coolant tank from the chips. 2. The reduction gear has already been lubricated with synthetic grease and, therefore, it does not require any maintenance. HB 210 A, HB 250 A... - Page 10 Please make sure to always assemble 0.9 mm thick blades for which the bearings of the blade guide have been adjusted. In case of thicker blades, if is necessary to adjust the blade guide once again as above mentioned. HB 210 A, HB 250 A...
-
Page 11: Circuit Diagram
Machine Tools OPERATING INSTRUCTIONS 8 CIRCUIT DIAGRAM HB 210 A, HB 250 A... -
Page 12: Spare Parts
Machine Tools OPERATING INSTRUCTIONS 9 SPARE PARTS HB 210 A, HB 250 A...
Need help?
Do you have a question about the HB 210 A and is the answer not in the manual?
Questions and answers