Steelcraft 3 IN 1 PORTABLE COT Manual

Table of Contents

4001071_B

Table of Contents

Need help?

Do you have a question about the 3 IN 1 PORTABLE COT and is the answer not in the manual?

Page 1 4001071_B...
Page 2 Cots with padded rails should not be used if the covered fabric is torn or bitten through. Do not use parts or accessories except those tested and approved by Britax. Always check that the folding parts are fully locked before using the cot.
Page 3 For its correct use, ensure you follow these instructions in the order that they are written. PARTS LIST 1 - Carry bag 1 - Mattress 4 - Mattress Support Rods 1 - Cot 1 - Bassinette 1 - Change Table 3 - Change Table Support Rods www.britax.com.au www.britax.com.au...
Page 4 RAILS IN PLACE.) worn or broken parts. Use only those parts and accessories tested and approved by Britax. Now do the same with the longer rails. WARNING: IF THE SIDES DO NOT LATCH FIRMLY OR THERE ARE HOLES IN THE NOTE: ALL THE TOP RAILS SHOULD BE LOCKED MESH SIDES, DISCONTINUE USE IMMEDIATELY AND SEEK REPAIR.
Page 5 FOLDING THE PORTABLE COT. EASILY FOLD THE COT. IF BASSINET OR CHANGE TABLE ARE FITTED, THEY MUST BE REMOVED BEFORE FOLDING THE COT. Release the loop straps that secure the mattress and remove the mattress from the cot. www.britax.com.au www.britax.com.au...
Page 6 Thread the straps through the plastic loops, pull them tight and secure using the hook and loop ALWAYS REMOVE THE BASSINET BEFORE FOLDING attachments. THE PORTABLE COT. Take the carry bag and cover the folded cot. Finish covering the cot and close the zipper. www.britax.com.au www.britax.com.au...

S600 series