EverHot EVH 100i Installation Instructions

NOTE: The preparation of the site, in readiness for the installation of the appliance, is the responsibility
of the site owner, not of the manufacturer of the appliance.
a.
The floor must be level
b.
It is important to ensure the flooring is laid before delivery and runs underneath the cooker. Flooring
should not be laid up to the cooker after installation.
c.
The cooker measurements are 600mm deep, 995mm wide and 900mm high to the working surface.
d.
The EVH 100i should be installed with a minimum of 30mm clearance from the back wall to allow for the
electric cable entry. This 30mm gap is best sealed by running the worktop behind the cooker, though a
standard 30mm stainless infill strip that fits to the back of the cooker is supplied.
the cooker be pushed hard against the back wall as this may damage the supply cable.
A minimum gap of 5mm per side is required to allow installation and removal of the cooker – please
e.
contact us in advance if this is not possible. Where the end grain of a wooden worktop is adjacent to the
cooker, we recommend increasing this to 10mm to minimise the chance of the worktop splitting.
f.
Clearance must be allowed for the raising of the cooker lids into the upright position (minimum height of
1530mm from ground level). Please see side view diagrams. A 5mm gap on each side of the cooker lid
should be allowed when in the raised position (the lid is 590mm wide to allow for overhead cupboards).
g.
Your cooker is not suitable for use with a solar diverter.
AC only and should be plugged into 2 separate standard 13 amp sockets.
be hard-wired to the household fixed
h.
If you wish to use the internet-connectivity features of the control box, ensure that a good to excellent
strength Wi-Fi connection is available in the location where the control box is to be located.
i.
The 13 amp sockets should be accessible and positioned adjacent to the cooker, so as not to impede
the opening of the top lid, and ensuring the plugs are not exposed to steam or excessive moisture. If the
socket cannot be positioned immediately adjacent to the cooker, please see diagrams attached for exact
lengths of cables (unfortunately it is not possible to extend these cable lengths). If a power supply
cord is damaged, it must be replaced by the manufacturer or their representative, as special purpose
tools are required.
Your EVERHOT cooker has been built to comply with the following UK and European Directives, and carries the UKCA and CE mark.
3. Electromagnetic Compatibility Regulations (2016) 4. Electrical Equipment (Safety) Regulations (2016)
Control of Substances - Health and Safety
This appliance contains the following substances indicated below. It is the User's/Installer's responsibility to ensure that the appropriate precautions
are taken when handling, where applicable, any of the materials that could be interpreted as being injurious to health and safety.
Mineral wool, Glass Yarn.
May cause irritation to the skin, eyes, nose and throat, may be harmful if inhaled. Use appropriate protective clothing to avoid contact with body. After
handling, wash hands and other exposed parts.
Your cooker does not contain ceramic insulants.
The EVERHOT is a high quality appliance that will provide decades of use, however when you feel that it has reached the end of its working life, please
contact us and we will remove it and recycle it free of charge
With Everhot Cookers' policy of continuous product improvement, the manufacturer reserves the right to change specifications and make
modifications to the appliance described and illustrated at any time
Version 2025
INSTALLATION INSTRUCTIONS & SPECIFICATION
PRE – INSTALLATION
and capable of supporting the weight of the cooker (approximate weight 350kg).
wiring. Please use the supplied 13A plugs.
1. EMC Directive (2014/30/EU) 2. Low Voltage Directive (2014/35/EU)
On no account should
The appliance must be used on 220-240V
An Everhot cooker should not