EverHot EVH 150 Pre-Installation

INSTALLATION INSTRUCTIONS & SPECIFICATION
NOTE: The preparation of the site, in readiness for the installation of the appliance, is the responsibility
of the site owner, not of the manufacturer of the appliance
a. The floor must be level
550kg).
b. The cooker measurements are 600mm deep and 900mm high to the working surface with a width
of 1490mm. The cooker should be installed with a minimum of 30mm clearance from the back
wall to allow for the electric cable entry.
behind the cooker, though a standard 30mm stainless infill strip that fits to the back of the cooker
can be bought from Everhot.
the back wall as this may damage the electric cable. A minimum gap of 5mm per side is required
to allow installation and removal of the cooker – please contact us in advance of installation if this
is not possible.
recommend that this is increased to 10mm to minimise the chance of the worktop splitting.
c. Clearance must be allowed for the raising of the cooker lids into the upright position (minimum
height of 1530mm from ground level). Please see side view diagrams for further clarification. A
5mm gap on each side of the cooker lid should be allowed when in the raised position (each lid is
590mm wide to allow for overhead cupboards).
d. The appliance must be used on 220-240V AC only and should be plugged into two standard 13
amp sockets. The 13 amp sockets should be accessible and positioned adjacent to the cooker, so
as not to impede the opening of the top lid, and ensuring the plugs are not exposed to steam or
excessive moisture. If the sockets cannot be positioned immediately adjacent to the cooker,
please see diagrams attached for exact lengths of cables (unfortunately it is not possible to extend
these cable lengths).
manufacturer or their representative, as special purpose tools are required.
should NOT be hard wired – please install using the supplied 13amp
Point a. below will normally be checked by the EVERHOT technician who installs your cooker
a. Before use, check that the cooker is level, upright and stable.
b. On reaching working temperature, ensure that the hot/simmer plate surfaces are flush with the
surrounds - this can be adjusted using a 5mm allen key in the bolts at each corner of the
hotplates.
c. On initial heating up odours may be given off from the insulants used. These will disappear
after a number of hours.
Your EVERHOT cooker has been built to comply with the following European Directives, and carries the CE mark.

Control of Substances - Health and Safety

This appliance contains the following substances indicated below. It is the User's/Installer's responsibility to ensure th at the
appropriate precautions are taken when handling, where applicable, any of the materials that could be interpreted as being
injurious to health and safety.
Mineral wool, Glass Yarn.
May cause irritation to the skin, eyes, nose and throat, may be harmful if inhaled. Use appropriate protective clothing to avoid
contact with body. After handling, wash hands and other exposed parts.
Your cooker does not contain ceramic insulants.
The EVERHOT is a high quality appliance that will provide decades of use, however when you feel that it has reached the
end of its working life, please contact us and we will remove it and recycle it free of charge
With Everhot Cookers' policy of continuous product improvement, the manufacturer reserves the right to change specifications and make
modifications to the appliance described and illustrated at any time
s:/installation specs/EVH 150 installation spec.doc/ver30415
PRE – INSTALLATION
and capable of supporting the weight of the cooker (approximate weight
On no account should any Everhot model be pushed hard against
Where the end grain of a wooden worktop is adjacent to the cooker, we
If the power supply cord is damaged, it must be replaced by the

POST INSTALLATION

1. EMC Directive (2004/108/EC) 2. Low Voltage Directive (2006/95/EC)
This 30mm gap is best sealed by running the worktop
EVH 150
An Everhot cooker
plugs.