Subscribe to Our Youtube Channel
Related Manuals for Barska WINBEST Pro-200
Summary of Contents for Barska WINBEST Pro-200
- Page 1 Pro-200 Edition Metal Detector ©2020 BARSKA® 855 Towne Center Drive | Pomona, CA 91767 2/20 BC638 (t) 888.666.6769 | (f) 909.445.8169 | www.barska.com...
- Page 2 Notes Before Use - If you are new to use metal detectors, it is recommended to set the sensitivity to a median level. Lower the sensitivity slightly in the event of false signals. - If the sensitivity is set too low, it may miss some valuable target. After you have become familiar with the detector, you may try it at full sensitivity.
- Page 3 Assembly Preparation Parts of the Metal Detector Assembling the detector is easy and requires no special tools. Just follow these steps. Search Coil Battery Compartment Control Box Headphone Jack Arm Support Middle Stem Lower Connector and Knob Stem 4. Search Coil Locknut Top Stem (S Stem)
- Page 4 6. When you stand upright with the detector in your hand, the search coil is level with and about 0.5~2 inches / 1~5cm above the ground. You can lengthen or shorten the stem basing on your height. After figuring out the suitable length, then tighten the lock nut.
- Page 5 • Set the volume to the lowest setting before you begin listening. LOW BAT When indicator lights up, replace the battery immediately. • After you begin listening, adjust the volume to a comfortable level. Rotate the control clockwise to power on the unit. Rotate it •...
- Page 6 2. Then, hold the search coil parallel with the ground about .5-2 inches/ 1-5 cm above the surface. Sweep the search coil from side to side in an arc line of 2.75 inches/ 7 cm motion. 3. When the detector detects a buried target, it sounds a tone.
- Page 7 Keep the detector away from dust and dirt, which can cause premature wear and Reassemble Locknut For Metal Detector tear of parts. If you encounter the problem to insert the lower stem to upper stem, please Wipe the detector with a damp cloth occasionally to keep it looking new. Do not use reassemble the locknut by following the steps below harsh chemicals, cleaning solvents, or strong detergents to clean the detector.
Need help?
Do you have a question about the WINBEST Pro-200 and is the answer not in the manual?
Questions and answers