Download Print this page

bemodern 1122 Installation And Operating Instructions Manual

2kw electric heater c/w thermostat control

Advertisement

Quick Links

200671_6
User instruction for fan heater model: These instructions should be read carefully and retained for future reference
I
N
mportant
otes
T
his product is only suitable for well insulated spaces or occasional use
D
o not use this appliance as a primary heat source
T
his heater must not be located immediately below a fixed socket outlet.
D
o not use the heater in the immediate surrounds of a bath, a shower, or a swimming pool.
D
o not cover this heater, or obstruct the air inlet or outlet, otherwise there is a risk of
overheating.
D
o not use outdoors
T
he heater must be cooled down completely before any maintenance
A
fter unpacking, please make sure that the appliance is intact, with no signs of damage caused by
I
transport.
f in doubt, do not use the appliance and contact the
D
uring normal operation this appliance will emit noise from the internal fan unit.
I
f the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
C
hildren should be supervised to ensure that they do not play with the appliance or handset
C
hildren of less than 3 years should be kept away unless continuously supervised.
3 years and less than 8 years shall only switch on / off the appliance provided that it has been placed in
its intended normal operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved.
and less than 8 years shall not plug in, regulate, clean the appliance or preform maintenance.
T
his appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
C
involved.
leaning and user maintenance shall not be made by children without supervision.
S
ome parts of this product can become very hot and cause burns.
where children and vulnerable people are in the vicinity.
D
o not use this appliance as a primary heat source
E
nsure that furniture, curtains and other combustible materials are positioned no closer that 1m from
the front of the fire.
D
o not run cord under carpeting, do not cover cord with throw rugs, runners or the like. Arrange cord
away from traffic areas and where it will not be tripped over.
D
o not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause
electric shock, fire or damage the appliance
D
o not block air intakes or exhaust openings in any manner
D
o not use on soft surfaces such as a bed, where openings may become blocked
I
f this fire is supplied through an extension cable, please ensure that it is the only appliance plugged into
the extension and that the instructions for the extension cable / reel are followed.
CAUTION
: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
T
his appliance must be positioned so that the plug / fused spur is accessible
I
n the event of a fault please disconnect the fire from the mains supply
W
T
arning:
his appliance must be earthed.
T
he wires in the mains lead connected to this appliance are coloured in accordance with the following code:
G
Y
reen and
ellow
B
lue
B
rown
A
s the colour of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows.
Y
ellow must be connected to the terminal in the plug which is marked with the letter
symbol or coloured
terminal which is marked with the letter
connected to the terminal which is marked with letter
2kW Electric Heater c/w Thermostat Control
Fire Installation and operating instructions: Models 1122
E
arth
N
eutral
L
ive
G
G
Y
reen or
reen and
N
T
ellow.
he wire which is coloured
B
T
or coloured
lack.
he wire which is coloured
L
or coloured
S
C
ervice
entre.
C
C
hildren aged from 3 years
P
articular attention has to be given
T
he wire which is coloured
E
or by the earth
B
lue must be connected to the
B
R
ed.
hildren aged from
G
reen and
rown must be

Advertisement

loading
Need help?

Need help?

Do you have a question about the 1122 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for bemodern 1122

  • Page 1 200671_6 2kW Electric Heater c/w Thermostat Control Fire Installation and operating instructions: Models 1122 User instruction for fan heater model: These instructions should be read carefully and retained for future reference mportant otes  his product is only suitable for well insulated spaces or occasional use ...
  • Page 2 200671_6 Preparation for use  Check that the supply voltage details on your fuel effect fire are in accordance with your electricity supply. Your fire is fitted with a plug incorporating a 13amp fuse. In the event of replacing the fuse in the plug supplied, a 13amp fuse approved by ASTA to BS 1362 must be used.
  • Page 3: Maintenance

    200671_6 Suite Version If the fire is already installed into a suite the transit screws will need to be removed prior to fitting the suite to the wall. Remove the fuel bed from the fire by lifting upwards, once removed the screws in the guard need to be removed and the guard itself. The two transit screws are in the base of the fire (see below) Thermostat: The thermostat is mounted at the right-hand side of the front face of the heater box and can be used to control the heat output to maintain a...
  • Page 4 200671_6 housing at regular intervals. This can be done using standard vacuum cleaner and suitable attachment. Additionally regular vacuuming of the inside of the fire bottom can be done using a standard vacuum cleaner attachment by removing the fuel bed. Coal Bed: This fire is supplied with a one piece removable fuel bed, to remove the fuel bed grip the top of the fuel bed and pull upwards, the fuel bed should slide out of position, Refitting is a reversal of the removal directions ensuring that the fuel bed sits on the brackets provided inside the fire.
  • Page 5 200671_6 Electric Fire Guarantee Be Modern Ltd. (the ‘Company’) provides a twelve month guarantee in respect of electric fire (the ‘Product’) ranges. The twelve month Guarantee applies to: All products in the ranges manufactured by the ‘Company’ (but subject to the exceptions below): where The product has been purchased and installed within the UK and in respect of The initial installation: and in favour of...
  • Page 6 200671_6 L 193/88  Official Journal of the European Union  21.07.2015  Table 2        Information requirements for electric local space heaters     Model identifier(s):   1122  Item  Symbol  Value  Unit     Item  Unit  Heat Output     Type of heat input, for electric storage local space heaters only  (select one)  Nominal heat output  P    2.0  kW     manual heat charge control, with integrated  [yes/no]  thermostat  Minimum heat  P    1.0  kW  [yes/no]  manual heat charge control with room and/or  output (indicative)    ...