bemodern 1640 Installation Instructions Manual

200701_1
1640 / 1640-50 / 1640-50 Portrait Models 2kw Electric Heater User /
I N
mportant otes
•
This heater must not be located immediately below a fixed socket outlet.
•
Do not use the heater in the immediate surrounds of a bath, a shower, or a swimming pool.
•
Do not cover this heater, or obstruct the air inlet or outlet, otherwise there is a risk of
overheating.
•
The heater must be cooled down completely before any maintenance
•
This heater must be fixed against a vertical surface.
•
Under no circumstances should the heater be used as a free standing appliance.
•
After unpacking, please make sure that the appliance is intact, with no signs of damage caused by transport. If in
doubt, do not use the appliance and contact the Service Centre.
•
During normal operation this appliance will emit noise from the internal fan unit.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
•
Children should be supervised to ensure that they do not play with the appliance or handset
•
Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3 years and
less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended
normal operating position and they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
•
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user
maintenance shall not be made by children without supervision
•
Some parts of this product can become very hot and cause burns. Particular attention has to be given where
children and vulnerable people are in the vicinity.
•
Do not use this appliance as a primary heat source
•
Ensure that furniture, curtains and other combustible materials are positioned no closer that 1m from the front of the
fire.
•
Do not stand the fire on the carpet – stand on a firm surface, which is free of dust and lint.
•
If this fire is supplied through an extension cable, please ensure that it is the only appliance plugged into the
extension and that the instructions for the extension cable / reel are followed.
•
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance must not be
supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on
and off by the utility.
•
This appliance must be positioned so that the plug / fused spur is accessible
•
In the event of a fault please disconnect the fire from the mains supply
•
If the fire is to be placed in front of an existing chimney opening and there is any risk of chimney debris falling down
onto the fire it is recommended that the flue or opening is sealed off with non-combustible non-fibrous insulation
materials. Do not place into an existing fireplace that is prone to dampness. Should it be necessary to cap and seal
the chimney to prevent personal injury, a professional should be hired to do the work
•
Warning: This appliance must be earthed.
•
If the fire is to be placed in front of an existing chimney opening and there is any risk of chimney debris falling down
onto the fire or drafts from the chimney it is recommended that the flue or opening is sealed off with non-combustible
non-fibrous insulation materials. Do not place into an existing fireplace that is prone to dampness. Should it be
necessary to cap and seal the chimney to prevent personal injury, a professional should be hired to do the work
The wires in the mains lead connected to this appliance are coloured in accordance with the following code:
Green and Yellow
Blue
Brown
As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows. The wire which is coloured Green and Yellow must be connected to the
terminal in the plug which is marked with the letter E or by the earth symbol or coloured Green or Green and Yellow. The
wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black. The
wire which is coloured Brown must be connected to the terminal which is marked with letter L or coloured Red.
Installation Instructions
These instructions should be read carefully and retained for future reference
Earth
Neutral
Live
Page 1