bemodern 1174 User Instruction

Led effect 2kw inset heater

Advertisement

Quick Links

200688_6

Important Notes

This heater must not be located immediately below a fixed socket outlet.
Do not use the heater in the immediate surrounds of a bath, a shower, or a swimming pool.
Do not cover this heater, or obstruct the air inlet or outlet, otherwise there is a risk of
overheating.
The heater must be cooled down completely before any maintenance
This heater must be fixed against a vertical surface.
Under no circumstances should the heater be used as a free standing appliance.
After unpacking, please make sure that the appliance is intact, with no signs of damage caused by
transport. If in doubt, do not use the appliance and contact the Service Centre.
During normal operation this appliance will emit noise from the internal fan unit.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Children should be supervised to ensure that they do not play with the appliance or handset
Children of less than 3 years should be kept away unless continuously supervised. Children aged from 3
years and less than 8 years shall only switch on/off the appliance provided that it has been placed or
installed in its intended normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3
years and less than 8 years shall not plug in, regulate and clean the appliance or perform user
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning
and user maintenance shall not be made by children without supervision
Some parts of this product can become very hot and cause burns. Particular attention has to be given
where children and vulnerable people are in the vicinity.
Do not use this appliance as a primary heat source
Ensure that furniture, curtains and other combustible materials are positioned no closer that 1m from the
front of the fire.
Do not stand the fire on the carpet – stand on a firm surface, which projects 250 mm (10 inches) beyond
the front of the fire and is free of dust and lint.
If this fire is supplied through an extension cable, please ensure that it is the only appliance plugged into
the extension and that the instructions for the extension cable / reel are followed.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility.
This appliance must be positioned so that the plug / fused spur is accessible
In the event of a fault please disconnect the fire from the mains supply
Warning: This appliance must be earthed.
The wires in the mains lead connected to this appliance are coloured in accordance with the following code:
GREEN and YELLOW
BLUE
BROWN
As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol or coloured Green or Green and Yellow. The wire which is coloured
Blue must be connected to the terminal which is marked with the letter N or coloured Black. The wire which is
coloured Brown must be connected to the terminal which is marked with letter L or coloured Red.
Model 1174 Electric Heater
User instructions for LED effect 2kw Inset Heater
These instructions should be read carefully and retained for future reference
Earth
Neutral
Live
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1174 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for bemodern 1174

  • Page 1 200688_6 Page 1 Model 1174 Electric Heater User instructions for LED effect 2kw Inset Heater These instructions should be read carefully and retained for future reference Important Notes • This heater must not be located immediately below a fixed socket outlet.
  • Page 2 200688_6 Page 2 Please unpack carefully ensuring that any loose parts and all packing items are removed. Read any warning labels carefully (see Maintenance Section). Place waste packaging back into box and dispose of RESPONSIBLY. The surround/appliance must be positioned so that plug or fused spur is accessible. Only when you are certain that you have completed the installation should you plug in and switch on at the wall socket.
  • Page 3 200688_6 Page 3 Trims (various) If your appliance is supplied with a trim please follow the below guidelines for fitting 1 Piece trim (3 sided) IMPORTANT: The trim is located in the rear of the surround. Do not discard trim with packaging. Please use the following instructions as a guide for fitting the optional 1 piece metal trim (only available with selected models).
  • Page 4 200688_6 Page 4 1 Piece trim (4 sided) Using 4 of the 7mm magnets supplied, double them up to make two sets of 14mm magnets. Position the two 14mm magnets as shown in FIG.8 close to the inside edge of the trim. Hook the top bracket over the top of the fire front and gently lower the trim into position, ensuring the trim does not slip with the pull of the magnets.
  • Page 5 200688_6 Page 5 Safety Thermal Cut-out and Thermal Link: This appliance is fitted with an Electric Safety Control (E.S.). This is a safety device, which switches off the fire if, for any reasons, the appliance overheats. The E.S. Control can only be re-set after the appliance has cooled down, in Order to re-set the E.S. Control, proceed as follows: •...
  • Page 6 200688_6 Page 6 Electric Fire Guarantee Be Modern Ltd. (the ‘Company’) provide a twelve month guarantee in respect of electric fire (the ‘Product’) ranges. 1. The twelve month Guarantee applies to: • All ‘Products’ in the ranges manufactured by the ‘Company’ (but subject to exceptions below); where •...

Table of Contents