hager domovea basic Operating & Assembly Instructions page 4

Introduction
2 Introduction
These instructions describe the safe and correct installation and commissioning of domovea basic and
domovea plus devices. These instructions are provided as information in addition to the product.
The illustrations and descriptions in this manual are for clarification purposes only and may differ from
the actual state of the software due to regular improvements being made.
Symbols used
Requirement. This requirement must have been met before continuing with the next assembly step.
l
Single-step instruction or any sequence
Multi-step instruction Sequence must be maintained.
1
– List
u
Reference to additional documents/information
Scope of delivery
KNX certified
Installation terminal with ac-
tuation opening
Suitable for use throughout
Europe and Switzerland
4
Installation by a qualified
electrician
Supports KNX Data Secure
Compatibility with
KNX S-mode (ETS)
Suitable for use in Morocco
Disposal note
Table 1: Symbols used
For further information on
configuring the device,
refer to the application
manual
Licence-free and open-
source connection stan-
dard for home automation
Compatibility with Hager
easyTool
Suitable for use in Aus-
tralia and New Zealand
Suitable for use in Eng-
land, Wales and Scotland