Page 1
IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS Digital copies of all IntelliVibe Mezzo manuals can be found at www.pentair.com, or by scanning the provided QR code. Se pueden encontrar copias digitales de todos los manuales de IntelliVibe Mezzo en www.pentair.com, o escaneando el código QR proporcionado.
Replacing the Light Assembly (In an Existing Pool or Spa) ......TROUBLESHOOTING ..................REPLACEMENT PARTS ................. IntelliVibe Mezzo Models ................IntelliVibe Mezzo Replacement Parts ............. Trim Ring Options ................... Trim Ring Dimensions ..................READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL...
Call (800) 831-7133 for additional free copies of these instructions. Please refer to www.pentair.com for more information related to this products. RISK OF ELECTRICAL SHOCK OR ELECTROCUTION: UNDERWATER POOL LIGHTS REQUIRE HIGH VOLTAGE WHICH CAN SHOCK, BURN, OR CAUSE DEATH.
Page 4
FOR LIGHT OPERATION, ONLY USE A SAFETY ISOLATION TRANSFORMER. FIXED POOL AND SPA LUMINAIRES SPECIFICATION: 14 VAC 50/60 Hz. IntelliVibe Mezzo Lights are approved to be installed in a vertical position (facing up). Vertical light installation must be installed minimum 4 inches below water level.
IntelliVibe Controller Maximum: 200 W • Individual Output Maximum: 100 W • IntelliVibe Mezzo Output: 24 W IF USING PS300 300 VOLT-AMP TRANSFORMER Maximum Number of Lights per 100 W OUTPUT: IntelliVibe Mezzo Maximum Number of Lights per CONTROLLER (sum of all outputs):...
LIGHT INSTALLATION IN 1.5″ WALL FITTING (USA) The following describes how to install the light in a 1-1/2” wall fitting. Note: IntelliVibe Mezzo lights are approved for horizontal and vertical installation. BEFORE STARTING: The following information describes the tasks that must be completed by the electrician before the light wall fitting is installed.
LIGHT INSTALLATION IN 1.5″ WALL FITTING (CANADA) Be sure the electrical system of your pool conforms with the following requirements of the Canadian Electrical Code (CE), and all local codes and ordinances. A licensed or certified electrician must install the electrical system to meet or exceed those requirements before the light and (fixture- housing) is installed.
CMP25550000000 HAYWARD SP1022 CMP25550001060 The IntelliVibe Mezzo light adapter allows the mounting of the light in the 1-1/2″ return fitting. Refer to the Compatible Wall Fittings table above. FOR FIBER OPTIC RETROFIT APPLICATIONS, SEE PAGE 8. WET CONDUIT INSTALLATION Note: The white threaded adapter is factory-installed onto the light assembly. This adapter allows the light to be threaded into most 1-1/2″...
Page 9
WET CONDUIT INSTALLATION (continued) With the light in hand, twist the light assembly approximately five turns counter-clockwise. This prevents twists remaining in the cord after the light is fully installed. Turn light counter-clockwise to twist cord. Ensure the inside of the wall fitting and threaded adapter are free of debris, then thread the light clockwise into the wall fitting until hand-tight.
WET CONDUIT INSTALLATION (continued) Install the IntelliVibe Mezzo Trim Ring by aligning trim ring tabs with channels on outer circumference of the Mezzo light. Gently push trim ring into the light until locking tabs click into position. Note: Select the correct trim ring size for the installation type by referencing the table Trim Ring Options on page 12.
Page 11
DRY/SEALED CONDUIT INSTALLATION (continued) 10. With the light in hand, twist the light assembly approximately five turns counter-clockwise. This prevents twists remaining in the cord after the light is fully installed. Turn light counter-clockwise to twist cord. 11. Ensure the inside of the wall fitting and threaded adapter are free of debris, then thread the light clockwise into the wall fitting until hand-tight.
DRY/SEALED CONDUIT INSTALLATION (continued) 12. Install the IntelliVibe Mezzo Trim Ring by aligning trim ring tabs with channels on outer circumference of the Mezzo light. Gently push trim ring into the light until locking tabs click into position. Note: Select the correct trim ring size for the installation type by referencing the table Trim Ring Options on page 12.
LIGHT WIRING INSTALLATION (continued) Refer to the IntelliVibe Controller Manual (P/N 619140) for wiring connections. Before operating the light, fill the pool with water until the light is completely submerged. DO NOT OPERATE LIGHT OUT OF WATER. WIRING DIAGRAM INTELLIVIBE™ MEZZO LED Light Installation and User’s Guide...
MAINTENANCE REPLACING THE LIGHT ASSEMBLY (IN AN EXISTING POOL OR SPA) This underwater light must be installed by a licensed or certified electrician or a qualified pool professional in accordance with the current National Electrical Code (NEC), NFPA 70 or the Canadian Electrical Code (CEC), CSA C22.1 and all applicable local codes and ordinances.
Ensure lights are wired to IntelliVibe controller correctly. Refer to the IntelliVibe Controller Manual (P/N 619140). Ensure IntelliVibe controller is installed properly and provisioned to the Pentair Home App. If 1-3 are all proper, measure the voltage being delivered to the light from the white and black conductors.
619129 619135 619112 619118 619124 619130 619136 Black 619113 619119 619125 619131 619137 Blue 619115 619121 619127 619133 619139 *Included with IntelliVibe Mezzo light. Note: Trim rings come in a 5-count bag. INTELLIVIBE™ MEZZO LED Light Installation and User’s Guide...
TRIM RING DIMENSIONS Refer to the below dimensional images for additional details of each trim ring geometry. DEEP SHALLOW (29 mm) (21 mm) Ø 5.2" Ø 5.2" (132 mm) (132 mm) 1.13" 0.83" (29 mm) (21 mm) 32 mm 16 mm 36 mm Ø...
Page 18
NOTES INTELLIVIBE™ MEZZO LED Light Installation and User’s Guide...
Page 19
NOTES INTELLIVIBE™ MEZZO LED Light Installation and User’s Guide...
Page 20
1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000 10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000 All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
Need help?
Do you have a question about the INTELLIVIBE MEZZO and is the answer not in the manual?
Questions and answers