McIntosh C50 Owner's Manual page 20

How to Operate the C50, con't
assigned to bypass the Equalizer. To bypass the Equal-
izer for a given Input Source, perform the following
steps:
Note: The audio signal present at the RECORD OUT
Jacks is unaffected by the Equalizer settings.
1. Select the Input Source to switch off the Equalizer
Mode.
2. Press the TRIM Push-button repeatedly until
"EQUALIZER MODE, ______: Enable" appears
on the Front Panel Information Display. Refer to
figure 63.
EQUALIZER MODE
TUNER
Figure 63
3. Rotate the VOLUME/ADJUST Control or press the
LEVEL + / - Push-buttons to Bypass the Equalizer
Mode. Refer to figure 64.
20
After approximately 4 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
MONO/STEREO MODE
By default the Stereo Mode is active for all Input
Sources however, any Input Source may be assigned
to Mono Mode. To change Stereo Mode to Mono for a
given Input Source, perform the following steps:
: Enable
Note: The audio signal present at the RECORD OUT
1. Select the Input Source to switch from Stereo Mode
to Mono.
2. Press the TRIM Push-button repeatedly until
"MONO/STEREO MODE, ______: Stereo"
Figure 50
EQUALIZER MODE
TUNER : Bypass
Figure 64
Jacks is unaffected by the Stereo/Mono setting.
appears on the Front Panel Information Display.
Refer to figure 65.
MONO / STEREO MODE
TUNER
Figure 65
3. Rotate the VOLUME/ADJUST Control or press the
LEVEL + / - Push-buttons to Bypass the Equalizer
Mode. Refer to figure 66.
MONO / STEREO MODE
TUNER
Figure 66
After approximately 4 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
DIGITAL AUDIO DISPLAY
By default the Digital Audio Display is switched Off.
To display information about the type of digital signal
present when any one of the five digital inputs is se-
lected, perform the following steps:
1. Select one of the Inputs assigned to an active digital
source.
Note: The USB-D/A Input may also be selected when
the C50 is connected to a computer.
2. Press the TRIM Push-button repeatedly until
"DIGITAL AUDIO, Display Info: Off" appears
on the Front Panel Information Display. Refer to
figure 67.
DIGITAL AUDIO
Display Info : Off
Figure 67
3. Rotate the VOLUME/ADJUST Control or press
the LEVEL + / - Push-buttons to switch On the
: Stereo
: Mono