McIntosh C33 Owner's Manual page 7

use a file to square the corners and smooth any ir-
regularities in the cut edges,
5. Install the Mounting Strips
In the hardware package you will find two mounting
strips and two sets of machine screws. For panels
that are less than ½ inch (12.7 mm) thick, use the ¾
inch (19.1 mm) screws; for panels that are more than
½ inch (12.7 mm) thick, use the 1¼ inch (31.8 mm)
screws.
Starting at the right-hand side of the panel, insert
a screw of proper length into the center hole in the
panel, marked B on the template. On the back of the
panel, align a mounting strip with the holes in the
panel and tighten the screw in the center hole until
the screwhead is pulled slightly into the wood.
Repeat this procedure to attach the mounting
strip to the left side of the panel.
6. Attach the PANLOC Brackets
Using two screws of proper length in the A holes on
each side, attach the PANLOC brackets to the cabi-
net panel; the short flange is mounted against the
front (face) of the cabinet panel. The screws pass
through the PANLOC bracket flange, the cabinet
panel, and then through the mounting strips
previously mounted.
7. Install the Instrument
Guide the AC power cord through the panel opening
to the back of the cabinet; then, slide the instrument
into the opening carefully so that the rails on the
bottom of each side of the chassis engage the
tracks on the mounting brackets. Continue to slide
the instrument into the cabinet until it is stopped by
the adjust position latches. Press the latches in-
ward, this permits the instrument to slide into the
cabinet until its front panel is flush with the cabinet
panel. Depress the PANLOC buttons at the lower left
and right corners of the instrument panel to lock the
unit firmly in the cabinet. Depressing the PANLOC
buttons again will unlock the instrument so that it
can slide forward to the adjust position; if you press
inward on the adjust position latches then you can
remove the instrument from the cabinet.
-5-