Installation Guide READ AND SAVE THESE INSTRUCTIONS MODEL NO.: 21584 21585 Total Height 18” Install your ceiling fan using the provided down rod. Measure your room height before installing the fan and consider alternative installation height options if a longer down rod is needed.
21584/21585 MODEL NO.: SAFETY TI WARNING: To reduce the risk of electrical shock, turn off the electricity to the fan at the main fuse box or circuit panel before you begin the fan installation or before servicing the fan or installing accessories.
21584/21585 MODEL NO.: CAUTION MOUNT WITH THE LOWEST MOVING PARTS AT LEAST 2.1 METRES ABOVE FLOOR OR GRADE LEVEL. WARNING All set screws must be checked, and retightened where necessary, before installation. WARNING: If an unusual oscillating movement is observed, immediately stop using the ceiling fan and contact the manufacturer, its service agent or suitably qualified persons.
21584/21585 MODEL NO.: Alternative Bulb Usage: CFL or Incandescent Bulbs may be used. Ensure the Max. Wattage indicated on the socket labels is not exceeded, and verify the bulbs do not get in contact with any metal part of the fan components (shade or motor housing) WARNING: DO NOT EXCEED INDICATED MAX BULB WATTAGE Note for Stained Glass shade items: The stained glass shade has been protected with mineral oil as part of the finishing process.
21584/21585 MODEL NO.: Partially loosen screws in slotted holes of canopy. Remove the other 2 screws (along with the star washers) -save for later use. Twist canopy to remove the hanging bracket. Install hanging bracket to outlet box using original screws, spring washers and flat washers provided with new or original outlet box.
21584/21585 MODEL NO.: *Required for Canadian Installation ONLY* To ensure consumer safety and satisfy Canadian regulatory requirements, a safety support cable is provided to help prevent the ceiling fan from falling. To install, please follow the instructions below. Parts 1. Using the provided screw, attach the safety cable hook to the ceiling joist near the mounting bracket. Ensure the cable hook is covered by the canopy.
21584/21585 MODEL NO.: Ceiling Fan Wiring WARNING: Failure to disconnect the power supply prior to the installation may result in serious injury and fire hazard. CODE SWITCH – see next diagram 1. Codes are set by pushing Dip switches up or down. It is imperative that the code used for both transmitter and receiver is exactly the same, otherwise the remote controller will not work.
21584/21585 MODEL NO.: Important: Make sure all electrical connections comply with Local Codes or Ordinances and the National Electrical Code. If you are unfamiliar with electrical wiring, or if the house/building wires are different colors than those referred to in the instructions, please use a qualified electrician.
21584/21585 MODEL NO.: Pay attention to the raised slot of the hanger, it should be stuck into the slot of the ball. Light Kit Assembly 1. Insert the terminals of lamp wire into the host lamp wire terminal. Put the canopy of the light kit on the terminal box and fix it with 3 screws.
21584/21585 MODEL NO.: Testing Your Fan CAUTION:The remote control can be programmed to multiple receivers or fans. Remove battery cover on back side of remote-control transmitter. Install two AAA1.5-volt batteries(included). Then, replace the battery cover. Warning: Batteries are to be inserted with the correct polarity.
21584/21585 MODEL NO.: Ceiling Fan Troubleshooting Guide Welcome to the River of Goods family! We’re honored you’ve decided to include one of our ceiling fans in your home. Problem Solution Fan/Lights do not start Check all fuses/circuit breakers • •...
Need help?
Do you have a question about the 21584 and is the answer not in the manual?
Questions and answers