Barska AX11902 User Manual

User Manual For
Fireproof Digital Keypad Safe
Read all instructions before using this safe.
WARNING
- Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe, gaining full
access to the safe and its contents.
- Gun Warning, do NOT storage items such as firearms,
combustible materials, or medication in this unit.
- The safe can withstands heat up to 1700°F for 1 hour. The
interior will reach up to 350°F. Avoid storing items such as
pearls, digital media, back up tapes, data cartridge, CD's etc.
These items sustain heat damage at temperatures much lower
than 350°F.
- The safe has a proprietary insulation that has a high moisture
content. To avoid humidity damage to contents we recommend
placing a desiccant or dehumidifier inside the safe to protect
the contents from rust or mildew.
- If you are storing delicate items such as jewelry, photos, etc.
we recommend putting them in an air-tight container, prior to
placing them in the safe for storage.
- In the event of a fire, we recommend caution when opening the
safe. If you feel unsure about opening the safe because of the
contents stored, contact your local fire department for
assistance.
- Store emergency keys in a secure place; NOT inside of
the safe.
NOTE: BARSKA is not responsible for any damage or lost
contents in the safe due to moisture.
NOTE: BARSKA is not responsible if the safe is stolen or
contents in the safe.
©2024 BARSKA® | Pomona, CA 91767 | www.barska.com
PARTS OF THE SAFE
B
A
Parts of the Control Panel
A. Handle C. LCD Screen
B. Override Key and Cover D. Key Pad
E
F
Parts of the Inside of the Safe Door
E. Initialization Button F. Battery Compartment
OPENING THE SAFE WITH ACCESS KEY
1. Remove the small cover by gently pulling on it, to expose the
access key slot
2. Insert the access key and turn key to the left to unlock
3. Turn handle to the right to open safe door
4. Turn access key to the right to lock, remove key and replace
small plug
NOTE
Store access keys in a secure place. NOT inside of safe
BATTERIES
C
1. Remove battery cover on the inside of the safe door
2. Insert 4 AA batteries into the battery compartment and pay
attention to the polarity of the batteries
3. Replace compartment cover
REPLACING BATTERIES
If LCD displays LO BAT, this indicates that the batteries are low.
1. Open safe by using the access key
2. Repeat steps 1-3 of "Batteries" above and replace old batteries
with new batteries
D
3. Close safe and ensure that the safe is locked
NOTE
After reinserting batteries safe retains last personal pin codes
saved
CREATING PERSONAL PIN CODES
For security purposes, change the factory default codes as soon as
possible and before placing valuables in the safe.
NOTE
1st default pin code is 1234
2nd default pin code is 123456
NOTE
Safe retains only two 3-8 digit pin codes
1st Personal Pin Code
1. Open safe either by default pin codes or access key
Note: A beep will sound for each key pressed
2. Input the factory preset pin code #1234# then press * button
rapidly, on the LCD screen one dash will be blinking
3. Input your personal pin code, press # to confirm the LCD
screen will show -----, input digit pin code again, press # to
confirm
4."Into" appears in the LCD screen which indicates that your pin
code is saved
See reverse side for more information
3/24
BC691