Performing A Spray Distance Test - Gardena AquaPrecise 16000 Operator's Manual

2.7 Performing a spray distance test

We recommend always carrying out the spray distance test before
installation (especially in the Pipeline box). The spray distance test
is used to check whether the required contour can be irrigated from
the selected location.
Note: The spray distance test is automatically prompted by the
GARDENA Bluetooth
The AquaPrecise can be aligned in any direction. We recommend
setting up the AquaPrecise in the garden so that the connection
faces towards the water source.
1. Place the AquaPrecise on the lawn at ground level at the cor-
rectly selected location (see "2.7 Performing a spray distance
test").
2. Temporarily connect the AquaPrecise to the water supply.
3. Turn on the water supply.
4. Briefly press the manual
The AquaPrecise is activated and the battery LED
the battery's charge status (see "3.3.2 Battery LED
5. Open the GARDENA Bluetooth
6. Move the water jet within the irrigation area (left / right) using
the GARDENA Bluetooth App.
7. Increase / decrease the watering distance limit to see if all
corners / edges can be irrigated.
Tip: If there is anything in the way, you can set a second location
for complete coverage of the irrigation area.
8. You can end the spray distance test once you are sure that
each contour point can be reached and that there are no
obstacles within the area.
9. Shut off the water source.
10. Install the AquaPrecise in the garden.
App whenever a new location is added.
®
button on the AquaPrecise.
!M
®
12
App on your mobile device.
shows
!Lb
").
!Lb