DeLonghi 24 E Operating Instructions Manual page 12

I I I I I I I I I I
I I I I I I I I
I I I I I I I I I I
I I I I I I I I
12
PROBLEMS ON STARTING AND DURING THE SELF CLEANING CYCLE
1.
Steady
The function selector has been turned to the self cleaning position with the oven
door open or not perfectly closed. Or the door has been opened before the cycle
has been started with confirmation from key 3
What to do:
Close the door and repeat previous cycle.
.
If after 5 minutes the door has not been closed
nal sounds for 30".
I I
What to do:
Close the door, press any program key to silence the audible signal and repeat the oper-
ations to start the cycle.
2.
door
The oven door has been opened after the self cleaning cycle has started (before
locking the door). The self cleaning cycle is zeroed.
What to do:
1. Close the door.
and
2. Turn the function selector to
.
If after 5 minutes the door has not been closed
nal sounds for 30".
What to do:
I I
Close the door, press any program key to silence the audible signal and repeat the oper-
ations to start the cycle.
3.
F0.00
The self cleaning cycle has been stopped and then started again when it was quite
a way through. The message is displayed after about 10 minutes and the self clean-
ing cycle is zeroed.
What to do:
1. Put the switch to
2. Wait for at least 15 minutes.
3. Repeat the operations to start the self cleaning cycle.
4. If after several attempts the message continues contact the Service Centre.
Caution: It is advisable not to stop the self cleaning cycle and then start it again
when it is quite a way through.
door
with AUTO flashing
P0•00
appears on the electronic program display with the letter
AUTO
flashing.
OFF
with AUTO flashing
OFF
.
door
flashes and an audible sig-
and repeat the operations to start the cycle.
door
flashes and an audible sig-
P