Player Maintenance - NAIM CD5I Owner's Manual

CDS3
5.5 Output Socket Selection
A pair of phono output sockets are fitted at the rear of the CDS3
to provide an alternative to the preferred DIN socket. Proceed as
follows to select the phono sockets.
With the player stopped, press and hold the remote handset
disp function (handset in CD mode) or front panel
until the CD player prog indicator flashes. Further operations of
the disp function will now cycle through each combination of the
two socket types (DIN only, phono only or both). The selected
option is indicated on the CD player display as shown below.
Socket Option
DIN
Phono
Both
Press and hold the disp
socket selection mode.
6.1 CDS3 Rear
RS232 RC5 input
interface
Notes
The RC5 input is intended to accept external control signals
for multi-room applications. Contact your dealer or Naim Audio
directly for further information.
The optional RS232 interface can provide external control of the
player in special custom installations. Contact your dealer or
Naim Audio directly for further information.
4
disp button
Player Display
O
o 0
O
o 0
function a second time to exit from

5.6 Player Maintenance

It is important for reliable operation of the CDS3 to ensure that
the surfaces of the transport platter and the underside of the
puck are free of dust or debris which can prevent the disc from
sitting properly and cause it to slip.
To clean the transport platter, take a piece of Blu-tack and
lightly apply it to the top surface of the magnetic metal hub,
picking up any material attached to it. Brush the plastic outer
edge lightly with your finger or a soft brush to ensure that it is
dust and particle free. Similarly, clean the puck with Blu-tack,
to remove debris from the three locating pins on its underside.
Take care not to damage the rubber pressure pads. Brush them
lightly with your finger or a soft cloth.
Do not, under any circumstances, use any solvents or fluids for
the cleaning process.
power supply input
DIN output
phono phono
XPS only output output
left right
CDS3 DIN Output
nc
ch1
ch2
-ve
nc