Cd555 In Use E5; Disc Loading E5; Player Maintenance E5; Player Door Reset And Calibration E5 - NAIM CD555 Owner's Manual

C D5 5 5
6 C D 5 55 In Use
6.1 D isc L oad ing
To open the transport door press the player
open
handset key. To load a disc place it on the platter followed
by the magnetic puck. Do not use a puck from any other Naim
CD player.
If the player is stopped the door will open automatically when
a hand is moved towards the proximity sensor located in the
player front panel display window.
To close the door press the player
open key. The door will also close if the player
handset play key are pressed.
Note:
If the door hits an obstruction the door indicator will flash
and the door will stop moving. Remove the obstruction before
attempting to open or close the door again.
Note: If the door is left open for five minutes it will close
automatically to prevent inadvertent damage or dust build-up
within the player.
If an HDCD ® encoded compact disc is loaded the CD555
Note:
will automatically recognise and decode it. The display will read
HDCD for a few seconds after play is pressed.
6. 2 Player Ma intenan ce
It is important for reliable operation of the CD555 to ensure
that the surfaces of the transport platter and the underside of
the puck are free of dust or debris which can prevent the disc
from sitting properly and cause it to slip.
To clean the transport platter, take a piece of Blu-Tack and
lightly apply it to the top surface of the hub, picking up any
material attached to it. Brush the plastic outer edge lightly with
your finger or a soft brush to ensure that it is dust and particle
free. Similarly, clean the puck with Blu-Tack, to remove debris
from its underside.
Do not, under any circumstances, use any solvents or fluids for
the cleaning process.
® , HDCD ® , High Definition Compatible Digital ® and Pacific Microsonics™ are either registered trademarks or trademarks of Pacific Microsonics, Inc. in the United States and/or other countries.
door
button or the
door button or the handset
play button or
6. 3 Player D o o r Rese t a n d Ca l i br at i o n
If at any time the player door fails to open or close correctly, or
the top panel door button flashes, the door may need re-setting
and calibrating. The procedures are as follows.
It may only be necessary to carry out the
procedure.
6.3.1 Door Position Calibration
Switch the player off. Hold down the top panel
switch the player on. The player display should read
the player off and, after a short while, back on again. If the door
button flashes this indicates that the
Calibration
procedures are necessary. Carry out the following
two procedures.
6.3.2 Door Reset
Note: Door Reset will also reset DIN/Phono Socket selection,
Display settings, RC5/RS232 settings and Control Mode setting
(see Section 16.2).
Switch the player off. Hold down the top panel
switch the player on. Switch the player off and carry out the
Door Motion Calibration
procedure.
6.3.3 Door Motion Calibration
With the door fully closed press and hold the top panel
play
and buttons and switch the player on.
The door will continually open and close and the level of open/
close gain adjustment will be displayed. Allow the player to
run until the values displayed for open and close have settled
to consistent values. The door should now open and close
consistently. Switch the player off and, after a short while, back
on again. The door should now operate correctly.
Position Calibration
door
button and
- -
. Switch
Door Reset Motion
and
stop
button and
door
E5