NAIM AV2 Owner's Manual page 12

9.0 av2 detailed setup
Step 1. The av2 display will show VI1 on the left hand side and 6CH, 8CH, ---, AN1 or
one of twenty possible source component types on the right hand side. VI1 refers to
Versatile Analog Input 1 and the right hand options to the type of source component
connected to the input. --- denotes an input set as unused. The 6CH and 8CH options re-
configure the DIN socket input connectors 1 and 2 to offer a combined set of analog
inputs routed direct to the av2 output volume control and output channels. Use the
or 6 keys (front panel: rotate rotary control) to select the option appropriate for the
source component connected to the input(s). Move to the next step by pressing 8
panel: mode button).
More! If you wish not to specify a specific source component for any input, the
right hand side of the display can either be left at its default setting, or be set
to "unused" by selecting ---. Inputs set to --- will not appear for selection
when in the av2 is used in operational mode.
More! Using inputs One and Two in combined mode enables the connection of
source components that may already offer multi-channel outputs - DVD Audio
and Super Audio CD for example. When operating in combined mode the input
channels available on the two DIN sockets are routed, via the av2 output
volume control, direct to the output connectors bypassing any internal signal
decoding processing.
Step 2. The av2 display will now show VI2 on the left hand side and AN2 or one of twenty
possible source component types on the right hand side. VI2 refers to Versatile Analog
Input 2 and the right hand options to the type of source component connected to the
input. Use the 4 or 6 keys (front panel: rotary control) to select the option appropriate
for the source component connected to the input. Move to the next step by pressing 8
(front panel: mode button).
More! If the 6CH or 8CH options have previously been selected for input VI1,
input VI2 will not be available or displayed.
Step 3. The av2 display will now show AN3 on the left hand side and one of eighteen
possible source component types on the right hand side. AN3 refers to Analog Input 3 and
the right hand options to the type of source component connected to the input. Use the
4 or 6 (front panel: rotary control) to select the option appropriate for the source
component connected to the input. Move to the next step by pressing 8
mode button).
Steps 4 to 10. Repeat the step 3 procedure for the remaining three analog inputs, the two
optical digital inputs and the two coaxial digital inputs each time selecting the
appropriate source component types using the
control). It is always possible to return to and adjust the previous input by pressing
2 (front panel: input button). Move to the next step by pressing 8
button).
Step 11. The av2 display will now show EXT on the left hand side and either RC5 or DAT
on the right hand side. EXT refers to the external control input socket and RC5 or DAT to
its state. When selected to RC5, the IR remote control is operational. This parameter must
be set to DAT for the multi-room/RS232 data interface to operate. Use the
(front panel: rotary control) to select either option.
More! Contact Naim Audio directly for a full list of RS232 control codes.
More! With DAT (data) selected, Remote Handset control is disabled. It can be
re-enabled using the front panel controls.
(front
(front panel:
4 or 6 keys (front panel: rotary
(front panel: mode
4 or 6
4
keys
11