Mains Lead; Non-Rewireable Mains Plugs; Fuse Carrier; Plug Fuses - NAIM ACTIVE Manual

4
4.0 Connection

4.1 mains lead

As the colours of the wires in the mains lead of this apparatus may not correspond with
the coloured markings identifying the terminals in your plug proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in
the plug which is marked by the letter E or by the safety earth symbol or coloured green
or green-and-yellow.
The wire which is coloured BLUE must be connected to the terminal in the plug which is
marked with the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal in the plug which
is marked with the letter L or coloured red.

4.2 non-rewireable mains plugs

If a non-rewireable plug is cut from a mains lead (for whatever purpose) the plug MUST
be disposed of in a way to render it totally unusable. Considerable shock hazard exists if
the cut-off plug is inserted into a mains outlet.

4.3 fuse carrier

Should the plug fuse carrier be damaged or lost, the correct replacement must be obtained
from your dealer or from Naim direct. Do not use the plug until the fuse carrier is replaced.

4.4 plug fuses

Replace only with ASTA or BS 1362 approved fuses.
note
This equipment has been tested and found to comply with the relevant EMC and Safety Standards,
and, where applicable, also complies with the limits for a class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult your Naim dealer or an experienced radio/TV technician for help.