Instructions for:
2871JC & 2872JC Sand & Water Table w/
Clear Tub
Hardware Package HAST
Qty
Description
(4)
XFCI
2" Locking Caster w/ U-shaped Mount
(16) XBTX
#6 x 5/8" Trusshead Screw
(16) XAUR 2" Decorative Screw
(1)
XAUS 4mm Hex Wrench
(1)
XAOF Sand and Water Table Cap
(1)
XEZI
Sand and Water Tub Valve
(2)
XAHJ
Spacer Washer (Larger Inside Dia.)
(1)
XAHK Bottom Spacer Washer (Smaller Inside Dia.)
Assembly Instructions:
1. Install the casters on both sides "A" using four #6 x 5/8" trusshead screws per caster and a medium
Phillips screwdriver.
2. Place one side "A" flat on the floor with all of the holes facing up.
3. Assemble the unit by placing all parts "B", "C", and "D" in the appropriate holes using the alignment
dowels to temporarily hold the assembly together.
4. Place the other side "A" with all of the holes facing down on top of parts "B", "C", and "D" by aligning
the dowels pins with the holes in the side to hold them temporarily in place.
5. Install the 2" decorative screws in the holes in the side and tighten all the screws securely with the
provided 4mm hex key wrench.
6. Carefully turn the whole unit over and repeat step #5.
(Continued on page 2.)
General Care & Maintenance Guidelines:
craft.com/generalcare
our Product Limited Warranty, available at
www.jonti-craft.com/warranty
DHAST – Rev. N – 02 May 2023
800-543-4149
507-342-5169
www.jonti-craft.com
www.jonti-
This product is covered by
Page 1 of 2
WARNING:
CHOKING HAZARD/SHARP POINTS- Assembly
hardware contains small parts and components
with sharp points.
Adult assembly required.
Required Tool:
Medium Phillips Screwdriver
4mm Hex Wrench (provided)
Attention: Liquids must be drained
from the table daily and the tub dried
with a soft cloth to prevent mold growth
and damage to the table. To avoid
damage to the cover and support pieces,
allow any remaining moisture to dry
prior to putting the cover on. Dry off any
moisture on the wood frame of the unit
using a soft cloth.
Jonti-Craft, Inc.
171 Hwy 68
P.O. Box 30
Wabasso, MN 56293
Need help?
Do you have a question about the 2871JC and is the answer not in the manual?
Questions and answers