Advertisement
Advertisement
Table of Contents
Related Manuals for WLIVE ADSG043
Summary of Contents for WLIVE ADSG043
- Page 1 V3.1 wlive-cs@devaise.com...
-
Page 2: General Guidelines
IMPORTANT INFORMATION READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE. GENERAL GUIDELINES • • Please read the following instruction carefully and use the product accordingly. • Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed. - Page 3 If you have any further questions, please feel free to contact us wlive-cs@devaise.com by email or official website: We will reply ASAP. Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponding to the list, and the quantity is correct.
-
Page 4: Exploded Drawing
EXPLODED DRAWING... - Page 5 PARTS M6x28 M6x23 M6x10 M5x50 M4x11 M8x20...
- Page 6 REMARK 1. Put a blanket under the board to avoid scratch or damage. Please do not screw too deep or too shallow. ×6 DEV ISE ×2...
- Page 7 ×2...
- Page 8 M6x10 ×2 ×2...
- Page 9 M6x10 M6x10 REMARK Please note that the holes indicated by fingers on the steel frame should face the same direction.
- Page 10 M6x23 REMARK Please note that the holes indicated by fingers on the steel frame should face the same direction. ×8 M6X23 M8X20 M6X28...
-
Page 11: Correct Location
REMARK Peel off the fixing adhesive on the back of the part CORRECT LOCATION Right Too far Cover FRONT ×4... - Page 13 REMARK Let the grooves on part be connected to the groove on part ×4...
- Page 14 origin wood - colored pure colored...
- Page 16 M6x10 M6x10 REMARK Please note that the holes indicated by fingers on the steel frame should face the same direction.
- Page 17 M6x23 M6X23 M8X20 M6X28...
- Page 18 M5x50 REMARK Please do not fully tighten screws until all screws are in place. ×4...
- Page 19 M8x20 M4x11 M6X23 M8X20 M6X28 ×5...
- Page 20 M6x28 ×4 M6X23 M6X28 M8X20...
- Page 21 M6x10 REMARK Please do not fully tighten screws at this step. ×2...
- Page 22 M6x10 REMARK Please fully tighten all the screws after they are in right place，including those in Step 18.
- Page 23 ×4...
-
Page 24: Wiring Instruction
Wiring Instruction REMARK Wiring as shown in the picture. -
Page 25: Remote Control Instruction
Remote Control Instruction 22 Dynamic Modes Very Smooth Effects Brightness Adjustable Ultra Slim Design 20 Static Colors Speed Adjustment Card Type RF Remote Dynamic Demo Mode Easy Remote Pairing Direct Color Select 1. Turn On/ Standby MODE 2/9. Dynamic Mode Adjust SPEED SPEED DEMO...
Need help?
Do you have a question about the ADSG043 and is the answer not in the manual?
Questions and answers