Table of Contents
Advertisement
Quick Links
PLEASE READ INSTRUCTIONS CAREFULLY BEFORE INSTALLATION!
APPLICATION
The XT CP 0004 provides temperature space monitoring with a backlit LCD. Depending on the
configuration, the units can display and output Temperature, Setpoint, and Fan Speed. A setup
menu provides easy output and display configuration changes.
INSTALLATION
Precautions
• R
EMOVE POWER BEFORE WIRING
WITH POWER APPLIED
.
BOARD
• A
N ISOLATION TRANSFORMER IS RECOMMENDED WHEN POWERING THE
DEVICE WITH
• D
O NOT RUN THE
WIRING
• F
AILURE TO WIRE DEVICES WITH THE CORRECT POLARITY WHEN USING A
SHARED TRANSFORMER MAY RESULT IN DAMAGE TO ANY DEVICE POWERED
BY THE SHARED TRANSFORMER
AUTOMATION COMPONENTS, INC
2305 Pleasant View Road
Middleton, Wisconsin 53562 (888) 967-5224
www.workaci.com
. D
O NOT ALLOW LIVE WIRES TO TOUCH THE CIRCUIT
24VAC.
TUC2
WIRING IN ANY CONDUIT WITH LINE POWERED
.
Installation and Operation Instructions
. N
EVER CONNECT OR DISCONNECT WIRING
.
Page 1 of 6
XT CP 0004 Model
Version : 3.0
I0000739
Advertisement
Table of Contents
Related Manuals for aci XT CP 0004
Summary of Contents for aci XT CP 0004
- Page 1 PLEASE READ INSTRUCTIONS CAREFULLY BEFORE INSTALLATION! APPLICATION The XT CP 0004 provides temperature space monitoring with a backlit LCD. Depending on the configuration, the units can display and output Temperature, Setpoint, and Fan Speed. A setup menu provides easy output and display configuration changes.
- Page 2 Five wires are needed for the XT CP 0004. One wire is required for each output, one wire for power, and one wire for ground. All outputs are common ground referenced.
-
Page 3: Operation
- +12 to +40 VDC or 20 to 28 VAC COM - Ground or signal common, 20 to 28 VAC - Temperature sensor signal to controller - Temperature set point signal to controller - Fan signal to controller OPERATION Normal Mode The LCD will display temperature and fan mode. -
Page 4: Setpoint Mode
Setpoint Mode Press to get into setpoint mode and change the setpoint. If no keys are pressed for 5 seconds the unit will automatically return to normal operation. Fan Mode Press to change the fan setting. F/C Mode Press to change the display temperature scale between F and C. This will change the temperature and setpoint scales. - Page 5 Additional Options Menu Temperature Menu RH Menu Display Menu Fan Menu System Menu Sensor Sensor Sensor Setup Setup Setup Setup Setup Setup Sensor Sensor Sensor Display Display Display Display Display Display Temperature Options Systems Options Additional Options SELECT RH Options Fan Options Display Options RH Offset...
-
Page 6: Warranty Statement
Approvals RoHS, REACH Warranty Statement The XT CP 0004 is covered by ACI’s Five (5) Year Limited Warranty, which is located in the front of ACI’s SENSORS AND TRANSMITTERS CATALOG or can be found on ACI’s web site, which is: www.workaci.com...
Need help?
Do you have a question about the XT CP 0004 and is the answer not in the manual?
Questions and answers