Dorman 99668 Instructions Manual

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
99668
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2024 No reproduction in whole or in part without prior written approval.
99668_Instructions
NOTE: There are two procedures
listed below. Always complete both
to ensure successful programming
of remote functions and ignition
key function. Transponder key
blank requires laser cutting for key
to start vehicle.
NOTE: One programmed remote (with
new battery) and key that starts
vehicle must be present to program
new remotes.
NOTE: Ensure all keys are present
when performing this procedure.
This procedure may erase previously
programmed keys not present during
programming. Remember which key
is original working key. If there is no
visual indication, mark original with
small piece of tape.
NOTE: A maximum of four keys can
be programmed per vehicle.
REMOTE
PROGRAMMING
INSTRUCTIONS
STEP 1:
Close all doors, trunk/liftgate, hood,
windows and sunroof (if equipped). Enter
vehicle through driver door and close it.
STEP 2:
Set switch on programmer to "Remote"
setting.
STEP 3:
Insert programming dongle into OBD-II port.
Programmer will beep and LED will flash
orange once to indicate power.
STEP 4:
Insert a working key and turn to key on,
engine off position.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 5:
Listen for programmer to respond. If
programmer beeps twice and LED flashes
orange, skip to Step 9. If programmer beeps
three or more times and LED flashes red,
proceed to Step 6.
STEP 6:
Simultaneously press lock and unlock
buttons on working remote portion of key
(still in ignition) for at least one second and
then release both buttons.
STEP 7:
Wait one second. Press unlock button on
same remote for at least one second and
then release button. Vehicle will either cycle
door locks or horn will beep when new
remote is learned. Programmer will stop
beeping and flashing.
STEP 8:
Wait for programmer to enter programming
mode. Programmer will beep twice and LED
will flash orange.
STEP 9:
On new remote, simultaneously press lock
and unlock buttons for at least one second
and then release both buttons.
STEP 10:
Wait one second. Press unlock button on
new remote for at least one second and
then release button. Vehicle will either cycle
door locks or horn will beep when new
remote is learned. Programmer will beep
three times and LED will flash green to
indicate successful programming.
STEP 11:
Turn ignition off. Remove key from ignition
and programmer from OBD-II port.
PAGE 1 OF 6