Dorman 99135 Instructions

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
99135

BEFORE YOU BEGIN:

• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
99135_Instructions
NOTE: All currently programmed and new remotes must be reprogrammed
to vehicle. Please have all remotes in hand at time of programming.
INSTRUCTIONS

STEP 1:

Insert key into ignition and turn to key on, engine off.
NOTE: Programming can be affected by voltage fluctuation. Ensure battery
voltage of 12.6VDC is maintained throughout this entire procedure.

STEP 2:

Insert programmer into the vehicle' s OBD-II port. This port is typically located
underneath the dashboard below the steering wheel.

STEP 3:

Once the programmer is inserted, wait for the programmer to chime followed by
a red flashing light on the programmer. This will indicate that the unit is ready to
program the first remote.

STEP 4:

While the light is flashing, press and hold the lock and unlock buttons on the
remote simultaneously for five seconds, then release and immediately press and
hold the unlock button until the programmer or vehicle responds with a chime
(approximately one second), buzzer, or the door locks lock and unlock, followed by a
one time flash of green. Release the unlock button.

STEP 5:

To program additional remotes, wait for the light to begin flashing red again and
repeat Step 4. All remotes (new and existing) must be reprogrammed during this
sequence.

STEP 6:

Remove programmer when all remotes have been programmed (up to four total).
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
PAGE 1 OF 3