Initial Netcommand Setup For Most Devices; Adding Or Removing Device Keys From Netcommand Control - Mitsubishi Electric LDTV152 - 52IN LCDtv 1920X1080 10000:1 S-vid Comp-vid USB Owner's Manual

56
6. NetCommand IR Control
Initial Net Command Setup for Most Devices
To perform this procedure, you need:
• The remote controls for both the TV and the
device you want to control.
• The IR emitter cable supplied with the TV.
Note: To set up an A/V receiver, see "Setting Up
NetCommand Control of an A/V Receiver," page
60 .
1.
Connect and position the IR emitters for the
devices you wish to control. See "IR Emitter Place-
ment" on the previous page .
2.
Set the TV's remote control slide switch to the TV
position and power on the TV if needed.
3.
Open the Net Command
ways:
• If working from the
for the device, highlight the Learn icon and
press ENTER to open the Learn screen for the
device.
• If performing Net Command setup at any time
after the device has been recognized through
Auto Input Sensing:
a. Press INPUT to open the Input Selection
menu.
b. Highlight the desired input icon and press
ENTER to switch to that input.
c. Press MENU, highlight Inputs, and highlight
Learn to open the Inputs > Learn screen
for the device.
4.
The first function highlighted in the
is always Power On. Aim the TV's remote control
at the TV and press ENTER to begin learning for that
function.
5.
When the Power On text starts flashing, aim the
device's remote control at the TV and press and
hold the POWER key until a check mark appears next
to Power On.
• If the text stops flashing before the check mark
appears, repeat the previous step.
• To remove the key from Net Command control,
press the CANCEL key while the key name is
highlighted.
6.
Press the
to highlight other keys on the list. Repeat steps
4 and 5 for each additional function you wish to
control through Net Command.
7.
If the device's remote control has keys that are not
in the list, you can associate up to any four keys
with the F1 through F4 keys. Perform Net Command
setup for the F keys the same way you did for the
named keys. For example, you can:
• Assign your DVD player's
CHAPTER SKIP BACK keys to F1 and F2.
Learn screen in one of two
Auto Input Sensing screen
Learn screen
keys on the TV's remote control
CHAPTER SKIP FORWARD and
From the Auto Input Sensing screen, highlight the Learn
icon and press ENTER to open the Net Command Learn
screen.
Inputs > Learn screen
• "Learn" your A/V receiver's DSP options for the
current device.
8.
If the device has a separate
on the TV's remote to highlight Power Off.
Repeat the earlier steps to "learn" the POWER OFF key.
If the device has no POWER OFF key, skip this step.
9.
Press EXIT to finish Net Command "learning" for the
current device.
Adding or Removing Device Keys
from Net Command Control
1.
Press INPUT to open the Input Selection menu, high-
light the device's icon and press ENTER.
2.
Open the Inputs menu and highlight the Learn icon.
3.
When the Learn screen displays:
• To add keys: Continue as described earlier
under "Initial NetCommand Setup for Most
Devices" on this page .
• To delete keys: Highlight the name of the key
you wish to delete and press CANCEL on the TV's
remote control to clear the check mark.
POWER OFF key, press