Controlling A/V Receiver Sound Volume - Mitsubishi Electric LDTV152 - 52IN LCDtv 1920X1080 10000:1 S-vid Comp-vid USB Owner's Manual

16
2. TV Setup
Setting Up TV Inputs, continued
Tips on Auto Sensing and Changing
Connected Devices
• Choose a different name for each input.
• Antenna inputs ( ANT 1/ANT 2) are never detected,
although you can turn off unused antenna inputs in the
Inputs > Name menu.
• You can change the device type displayed in the
Selection menu by using the Inputs > Name menu ( page
50 ). Any "learned" Net Command IR codes will be erased,
however.
Changing Devices on an HDMI Input
1.
Disconnect the HDMI device.
2.
Delete the HDMI input in the
See page 50 .
3.
Connect the new device and the
Sensing screen will display. If you want the device
under Net Command IR control, perform Net Com-
mand "learning" for the new device.
Disconnecting an Analog A/V Receiver
When you disconnect an analog A /V receiver, be sure
to change the Speakers setting to TV to:
• Hear sound from the TV speakers.
• Redisplay the Auto Output Sensing screen when
you reconnect a device to the AVR AUDIO OUTPUT.
Change the setting using the remote control's AUDIO key
or the AV > Audio > Speakers menu.
Resetting the SUBWOOFER OUTPUT Jack (AVR
AUDIO R)
Follow these steps to enable redisplay of the Auto
Output Sensing screen.
1.
Repeatedly press the
woofer option and change it to Off.
2.
Power off the TV.
3.
Disconnect the subwoofer from the TV.
4.
Power on the TV.
5.
Connect the device to the
(AVR AUDIO R) jack and the Auto Output Sensing
screen will display.
Input
Inputs > Name menu.
Auto Input
AUDIO key to display the Su b-
SUBWOOFER OUTPUT
C ontrolling A/V Receiver Sound Volume
Use one of the methods below to control sound volume from
the A/V receiver.
With a Standard TV Setup
• Recommended Method:
remote control for your A/V receiver and enable the
Audio Lock feature. See page 70 .
• Program the TV's remote control for your A/V
receiver and set the TV remote's slide switch to the
AUDIO position to control A/V receiver volume. Set
the switch back to the TV position to control the TV.
• Use the remote control that came with the A/V
receiver.
With NetCommand IR Control
Set up NetCommand control of the A/V receiver's
volume functions in the Inputs > AVR menu. The TV's
remote will then control A/V receiver volume. See page
60 .
With NetCommand for HDMI (CEC-Enabled
HDMI A/V Receiver)
The TV's remote control may control some functions
of the A/V receiver. See "About Home-Theater Control
Systems," page 17 and Appendix E , page 80 .
Program the TV's