JumpSport bounti x Sled 360 System Manual

Download this manual

bounti x JumpSport Sled 360 System

Terms & Conditions

Installation Guide

Please Note:

The Sled 360 System is designed to act as an enhancement to your JumpSport or bounti

Rebounder so that it can be used as a resistance sled system, over an even and proper surface.

Get more out of your JumpSport or bounti Rebounder by loading up the sled with weights. Soft

weights like sandbags are ideal, but if you use steel weights, make sure that they are centred and

properly secured, and will not create wear on your rebounder.

Note: This device is NOT made for folding trampolines.

1) Remove the existing rebounder leg caps / feet from the 6 leg assemblies. Slide Long Leg Caps

onto each leg so that they are fully seated.

2) In an area where you intend to use the device, install Sled 360 feet over long leg caps.

Carefully flip the rebounder upright.

3) Your Sled 360 System is now ready for proper use.

4) Be sure to reinstall the standard rebounder leg caps when using the trampoline as a

rebounder.

Warranty

bounti x JumpSport Sled 360 System Limited Warranty

The Sled 360 System comes with a limited warranty of 90 days, covering

defects in materials and workmanship. This warranty is valid only upon initial

receipt of the product and covers the following conditions:

- Tears on the Long Cap and any visible cracks on the Sled 360

System discovered during the ﬁrst installation.

Need help?

Do you have a question about the bounti x Sled 360 System and is the answer not in the manual?

Page 1 Rebounder so that it can be used as a resistance sled system, over an even and proper surface. Get more out of your JumpSport or bounti Rebounder by loading up the sled with weights. Soft weights like sandbags are ideal, but if you use steel weights, make sure that they are centred and properly secured, and will not create wear on your rebounder.
Page 2 ﬁrst installation. Disclaimer Product Disclaimer for the bounti x JumpSport Sled 360 System - The Sled 360 System is designed solely for use as an accessory during bounti rebounding routines (as demonstrated by Lisa Raleigh) or similar exercises that do not involve throwing, kicking, or extensive movement.
Page 3 • The Sled 360 System is designed for use only with a rebounder by JumpSport or bounti. • Do not attempt to use the Sled 360 on a frame with handle legs installed or connected to the legs. • Sled 360 feet are made of steel and have a steel base. Therefore, the Sled 360 is only designed to be used on surfaces like natural or artificial grass, or over surface that can take abuse in a gym.
Page 4 7. Avoid Sharp Objects: Use of the Sled 360 Systems on rocky areas with sharp objects voids any warranty claims. By following these guidelines, you can ensure the longevity and safe use of your bounti x JumpSport Sled 360 System. See full assembly video HERE.