JumpSport Universal Trampoline Frame Pad Builder Kit Standard Assembly Instructions

Download this manual

Universal Trampoline Frame Pad Builder Kits (Standard & Deluxe)

Standard Components

A. 8 Foam Inserts

B. 8 Vinyl Covers

C. 16 Pad Connectors

D. 16 Button Bungee T-Anchors

To Install Standard Foam Kit:

Step 1 - Lay Out Each Section

Lay out the standard pad foam and cover as pictured

with the hook and loop opening on the underside of

the pad cover facing up. The circular cutout in foam

will be positioned under the grommet holes in the

vinyl cover. The shorter layer of foam will be facing up

so that the longer layer of foam will be closer to the

top of the pad once assembled.

Step 2 -Insert Each Section

Insert the foam into the cover and adjust so the foam

is ﬂat and cutouts in foam are lined up with grommet

holes in the cover.

Proceed to Button Bungee Instructions

Assembly Instructions

Deluxe Components

A. 8 Long Foam Inserts

B. 16 Short Foam Inserts

C. 8 Vinyl Covers

D. 16 Pad Connectors

E. 16 Button Bungee T-Anchors or 8 Pad

Connector Bungees

Need help?

Do you have a question about the Universal Trampoline Frame Pad Builder Kit Standard and is the answer not in the manual?

Page 1 Assembly Instructions Universal Trampoline Frame Pad Builder Kits (Standard & Deluxe) Deluxe Components Standard Components A. 8 Long Foam Inserts A. 8 Foam Inserts B. 16 Short Foam Inserts B. 8 Vinyl Covers C. 8 Vinyl Covers C. 16 Pad Connectors D.
Page 2 To Install Deluxe Foam Kit: Step 1 - Lay Out Each Section Lay out the Deluxe pad foam and cover as pictured with the hook and loop opening on the underside of the pad cover facing up. The circular cutout in foam will be positioned under the grommet holes in the vinyl cover.
Page 3: Pad Installation
Step 1 - Close Velcro Sections Close Velcro to enclose foam and assemble button bungee as shown threading one “button” onto ends of bungee Step 2 - Attach T-Anchor Bungees Put the end of bungees through the grommet hole to the other side of the pad.
Page 4 To Install Pad Connector Bungees: Step 1 - Install Pad Bungee Install pad connector bungees through the 2 metal grommets near outside edge of pad, as shown. Grommets should be on bottom side of pad between legs. Step 2 - Tuck Pad Skirt Lift frame pad between poles 1 and 2.
Page 5 Step 3 - Secure Net with Pole Straps (purchased separately) Wrap 10.5ft pole strap around rail and through bottom strap of outer panel of net. Continue wrapping pole strap around the rail and bottom strap of net until you get to pole 2. Do not wrap pole strap around net mesh, only around bottom strap of net.

Universal trampoline frame pad builder kit deluxe