TWO TREES TTS Pro Product Manual page 6

3.5 Tensioner Installation
① You need to disassemble the tensioner first, unscrew the hand screw of the tensioner
to take out the Tensioner Inner Parts and unscrew the top
② Put the timing belt of the carriage on the idler of the tensioner, and then lock the
screw to the inner part of the tensioner
③ Push the tensioner internals into the tensioner housing shell (Tensioner has a fixed
slot, pay attention to the installation method)
Tensioner has slot, pay attention to assemble them in
right direction and push them in into the right position
④ Lock up the tensioner retaining screws
screw M4*20 x2
The teeth of the timing belt should face the guide groove
07
screw to take out the idler.
Tensioner
Tensioner
shell
Internal parts
Tensioner
housing shell
M4*20
4. Adjust the X-axis beam to make sure it is parallel with the front
and back frame.
Thumb
screws
Note: When installing, please make sure that the X-axis beam is parallel to the front and
rear beam profiles. You can use the rectangle on the scale for auxiliary adjustment.
Without parallelism, the Y-axis will be difficult to move and affect the engraving effect.
5. Tighten the X-axis synchronous belt.
Note：
Synchronous belt needs to be tightened, otherwise it
may cause the problem of engraving misalignment.
Tighten the thumb screw
Thumb screw
Note:
① It is the most appropriate position to feel a
little friction between the POM wheel and the profile
when rotating the POM wheel.
the profile, the eccentric nut can be adjusted
clockwise from the direction of the screw head with
an open-end wrench.
EN
Note: Install the laser module
at a vertical angle (90°).
② If the wheel rotates in the air and does not fit
08