Tektronix 3A9 Instruction Manual page 77

Performance Check/Calibration—Type 3A9
Signal Generator,
50 cable with 500
BNC connectors Termination
Set the Type 3A9 controls: Input Coupling pc
VoLts/DIV 10 mv. Tine) Diy Vins
VARIABLE CAL Slope as
UPPER —3dB FREQUENCY 1 MHz Source Int
'AC-GND.DC —INPUT GND 32. Check Signal Output Frequency Response
STEP ATTEN DC BAL Adjusted for DC balance
'0. Test equipment is shown in Fig. 5-38.
Amplitude Signal Generator Output
. Connect @ cable with BNC connectors to the GR to BNC 1e/Div sims
Noeble: ore . Connect «50. termination to the cable.
Coupling AC f e . Connect the termination to the Type 3A9 +-INPUT.
Source Int f . Set the Constant Amplitude Signal Generator controls
Trigger Mode Auto 'an follows
Amplitude Range 50-500 mV
Set the Test Oscilloscope controls: erties 5
Volts/Div lv Frequency Range 50 kHz only
Variable Cali Frequency Variable 75
® 5-39