Assembling And Hanging The Fan - Hunter 20552 Owner's Manual And Installation Manual

WARNING: Fan may fall if not assembled as directed in these
installation instructions .
3-1 . Unbundle the wires from the fan .
For Standard or Angled mounting:
3-2 . To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring . Feed the
wires from the fan through the downrod .
3-3 . Loosen the square head setscrew on the adapter to install the pipe
and ball assembly . Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal .
Securely retighten the setscrew with a wrench or pliers . Skip to
Step 3-7 .
CAUTION: The adapter has a special coating on the threads . Do
not remove this coating; the coating prevents the downrod from
unscrewing . Once assembled, do not remove the downrod .
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the low
profile washer .
3-4 . Remove the setscrew from the adapter .
3-5 . Place the low profile washer (lip up) into the canopy . Be sure the
green ground wire is pointing up toward the ceiling .
3-6 . Align the holes in the washer with the holes in the adapter .
Assemble securely with three low profile screws .
3-7 . Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim .
Step 3-7
3 • Assembling and Hanging the Fan
U-shaped
Hole
8
42751-01 • 08/12/10 • Hunter Fan Company
Steps 3-2 – 3-3
Steps 3-5 – 3-6
Low Profile Washer
Low Profile Screw
Downrod
Canopy
Canopy
Trim Ring
Setscrew