Installing The Canopy - Hunter 20531 Owner's Manual And Installation Manual

Step 5-1
Tab
Groove
Step 5-2
Step 5-3
5 • Installing the Canopy
5-1 . Rotate the hanger ball so the tab in the canopy is secure in the
groove in the hanger ball .
WARNING: Failure to complete this step could cause fan to fall .
5-2 . Lift the fan and align the canopy screw holes with the mounting
holes on the ceiling plate .
5-3 . Partially install a canopy screw into the side opposite the ceiling
plate tabs .
5-4 . Partially install another canopy screw into the hole between the
two ceiling plate tabs . Securely tighten both screws .
5-5 . Using both hands, push the canopy trim ring up to the top of the
canopy . The canopy trim ring will snap and lock into place .
Should you need to remove the canopy
trim ring, follow these steps:
Step 5-4
10
42450-01 • 11/18/10 • Hunter Fan Company
1 . Locate the tab indicators, small
bumps on top of tabs .
2 . Press firmly on opposite sides of the
ring toward the canopy . The tabs will
flex out releasing the trim ring from
the canopy .
Step 5-5