Contents Hot tub performance specifications Preparation for the installation of the hot tub Preparation of the place for installation and connection to electricity ... . Preparation for the interior hot tub installation ......Preparation for the exterior hot tub installation .
Hot tub performance specifications For your own safety and the safety of your product, please observe the following instructions. Read the following information carefully and follow the user manual exactly when using the hot tub to avoid damaging the product or the risk of injury. This appliance is intended for use by children 8 years of age or older with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, provided they are under supervision or have been instructed on the use of the product and understand the risks Children must not play with the product Cleaning and maintenance must not be performed by children without supervision. Hot tub performance specifications Performance specifications rated voltage: three-phase connect 230/400 V 50 Hz*...
Preparation for the installation of the hot tub Recommended Type C circuit breaker Hot tubs with two massage motors: 3× 16 A /C or D Hot tubs with three massage motors: 3× 20 A/C or D !!!THE HOT TUB MUST ONLY BE CONNECTED BY A PERSON WITH PROFESSIONAL ELECTRICAL QUALIFICATION IN ACCORDANCE WITH DECREE NO 50/1978 COLL !!! Preparation for the installation of the hot tub...
Preparation Installation of the hot tub Preparation for the interior hot tub installation If the hot tub is installed in an interior space, it is necessary to comply with safety instructions. The basic safety requirements are mainly non-skid floors and drainage in the place of the installation in case of a water overflow.
Installation of the hot tub/Audio system Aquatic 3.2 Filling the hot tub with water Fill the hot tub with a sufficient amount of water. The level of water in the hot tub cannot ever fall under the skimmer level. If you notice a water leak, stop the water until the defect is fixed.
Control panel Control panel (BALBOA SpaTouch 4) REVIEW HOME SCREEN Review home screen A Invert display Panel is locked and/or Settings Time is locked Message (may appear) M Water temperature display D Download software update and control button NOTE: not all control systems are...
Home screen Control panel 5.2 Review interface and navigation Home screen Home screen REVIEW INTERFACE AND NAVIGATION NOTE: not all control systems are configured the same. NOTE: not all control systems are configured the same. NOTE: not all control systems are configured the same. Spa devices, Settings, and various menu items may vary Spa devices, Settings, and various menu items may vary Spa devices, Settings, and various menu items may vary...
Control panel Home screen VIEW S Swipe up/down to view the Setting menu. Settings screen Swipe right here (if available) to view the Chromazone screen. Change the Set Temperature. View the message screen. Swipe down to go back to the Home screen. NOTE: not all co Spa devices, Se Spa screen.
Home screen Home screen SET THE TIME Control panel Set the time Home screen Home screen SET THE TIME Font: Anton Regular Font: Anton Regular Font: Roboto Bold Font: Roboto Bold Follow these steps to set the time: Font: Roboto Regular Font: Roboto Regular –...
Home screen Home screen CHANGE/VIEW THE CHANG Control panel SET TEMPERATURE SET TE 5.5 Change /View the set temperature Home screen Home screen CHANGE/VIEW THE SET TEMPERATURE Follow these steps to change the Set Temperature: – Press the water temperature display/button to view the temperature screen This is the water temperature , and this is the Set Temperature...
Home screen Home screen RUN SPA DEVICES Control panel Run spa devices Home screen Home screen RUN SPA DEVICES A spa device is a pump, blower, light, etc. Follow these steps to run spa devices: SET DISPLAY BRIGHTNESS – Swipe right here to view the Spa screen –...
SET DIS Control panel 5.7 Set display brightness Home screen SET DISPLAY BRIGHTNESS Home screen Home screen SET FILTER CYCLE TIMES SET FIL Font: Anton Regular Font: Roboto Bold Font: Roboto Regular Home screen Home screen Font: Roboto Light Follow these steps to change the display brightness: SET FIL SET FILTER CYCLE TIMES Font: Roboto Thin...
Control panel Keep your water clean and ready to enjoy! Follow these steps to set the fi lter cycles (see pictures on previous page): – Swipe down here to go to Settings . Press Filter Cycles to view the Filter Cycles screen –...
Home screen Home screen CHANGE HEAT SETTINGS CHANG Control panel SET HEAT MODE SET HEAT MO 5.10 Change heat settings (set heat mode) Home screen Home screen CHANGE HEAT SETTINGS SET HEAT MODE There are two temperature ranges: High and Low (G). High There are two t Range may limit the Set Temperature range to 80°...
Control panel looks for opportunities to decrease device usage by evaluating water temperature readings. Stable water temperatures equal less device usage and less CHANGE SLEEP SETTINGS wear and tear. Note: M8 is not available on all control systems. 5.11 Change sleep settings CHANGE SLEEP SETTINGS Follow these steps to set the general settings: –...
Upkeep of the hot tub Upkeep of the hot tub General information Do not expose the hot tub to sun without water inside or a cover on top. The direct sunlight can cause fading and deformation of the surface material. When you are not using the hot tub, cover it with the thermo cover, regardless of whether it is empty or full.
Page 18
Upkeep of the hot tub Adjust the water pH level accordingly by suitable water chemicals (the HANSCRAFT SPA – pH PLUS and pH MINUS is recommended). Adjust the Cl (chlorine) level with suitable water chemicals (HANSCRAFT SPA – MULTI MINI 3 in 1 tablets are recommended). Follow the instructions on the chemicals‘...
Upkeep of the hot tub 6.4 Replacing the water It is important to keep the hot tub water fresh and clean. We recommend you to replace the water at least every 3 months unless the water quality drops sooner. The hot tub water can be used for watering the garden for example, given that it has not been chemically treated at least one week prior.
Upkeep of the hot tub / Winter and summer time The right balance of water chemicals represents an important factor in prolonging the longevity of your hot tub thermocover. Remove the hot tub's cover and place it on the ground surface down. Wash the cover with a large amount of water from a garden hose or a water bucket.
Winter and summer time/Final establishments If the instructions above are not complied with and it results in a damage of the hot tub, the warranty cannot be claimed Summer time Do not expose the hot tub to direct sunlight; do not use inappropriate cleaning deter- gents for upkeep. Prevent the hot tub surface coming in direct contact with chemicals as well as surface scratches cause by sharp objects.
Repair services chart / Supplements Repair services chart A TABLE FOR YOUR NOTES, PLEASE FILL OUT THE FOLLOWING INFORMATION You will need the filled out information in case of a repair requested through the customer service line. Purchase date Delivery date Model name Serial number Seller information (name, phone number) 10 Supplements...
Page 24
23. 7. 2024 HANSCRAFT, s r o Safety K Vodojemu 140 Regular 252 19 Chrášťany u Prahy Production CZECH REPUBLIC Surveillance w w w H A N S C R A F T eu w w w.tuv.com ID 0000073072...
Need help?
Do you have a question about the SPATOUCH 4 and is the answer not in the manual?
Questions and answers