Advertisement
• Before mounting, connect the units temporarily. Check that the
units are connected correctly by operating the multi-CD controller.
• After connection is complete, press the clear buttons on the play-
er and the multi-CD controller with the tip of a pencil.
• Be sure to connect the ground lead (black) to the vehicle body or
some other metal part that is properly grounded to the chassis. If
the ground lead is not properly connected, noise may occur or the
player or multi-CD controller may not operate correctly.
• This product is for vehicles with a 12-volt battery and negative
grounding. Before installing it in a recreational vehicle, truck, or
bus, check the battery voltage.
• To avoid shorts in the electrical system, be sure to disconnect the
battery (-) cable before beginning installation.
• Check whether installation and wiring have been completed cor-
rectly. Replace the removed car components, then connect the
end of the cable to the negative (-) terminal of the battery.
• Secure the wiring with cable clamps or adhesive tape. To protect
the wiring, wrap adhesive tape around them where they lie
against metal parts.
• Route and secure all wiring so it cannot touch any moving parts,
such as the gear shift, handbrake, and seat rails. Do not route
wiring in places that get hot, such as near the heater outlet. If the
insulation of the wiring melts or gets torn, there is a danger of the
wiring short-circuiting to the vehicle body.
• Don't pass the yellow lead through a hole into the engine com-
partment to connect to the battery. This will damage the lead
insulation and cause a very dangerous short.
• Do not shorten any leads. If you do, the protection circuit may fail
to work when it should.
• Never feed power to other equipment by cutting the insulation of
the power supply lead of the unit and tapping into the lead. The
current capacity of the lead will be exceeded, causing over heat-
mg.
• Replace fuses only with the types stipulated on the fuse holder.
• Even if the power is cut off because the power cord is removed or
the battery is replaced, the CD title display and ITS memory are
retained for 24 hours.
Advertisement
