Technical Assistance - Jensen HD5112 Installation And Operation Manual

HD5112
Removing the Radio
To remove the radio after installation,
remove the trim ring by pulling outward
on one side and then the other. Insert
the removal keys straight back, with the
notches facing up, until they lock. With
the removal keys engaged, pull the
radio straight out. If removal keys are
REMOVAL KEYS
inserted at an angle, they will not lock
properly to release the unit.
Connecting the Satellite Radio Receiver
(optional)
Before you can listen to satellite radio, you must install the satellite receiver
and antenna (purchased separately). The satellite radio receiver is the
central data receiving equipment required to process the satellite signals
from the external antenna. It is typically installed in the dash, under the seat,
or in the trunk or rear of the vehicle. Do not mount receiver near a heater
vent or where it can be exposed to extreme temperatures. In addition, when
running the wire for the external antenna do not kink or pinch the antenna
cable. A sharp 90 degree bend or slight "nick" to the outer cable sheath will
cause signal degradation. The wiring diagram will help you identify the
proper connections.

Technical Assistance

If you require assistance, contact Technical Support at 1-800-323-4815
from 9:00am to 6:00pm EST Monday through Friday.
6