Front Panel Release - Jensen HD5112 Installation And Operation Manual

HD5112

Front Panel Release

The (open) button (9) releases the mechanism that holds the front panel
to the chassis.
Detaching the Front Panel
To detach the front panel:
1. Press and hold the power button (1) to turn the unit off.
2. Press the open button (9) and allow the front panel to fold down.
3. Lift the front panel to a 30-45
4. Pull to release the right side of the panel.
5. Pull the left side of the panel to remove it.
6. After removing the front panel, store it in the supplied carrying case and
take it with you when you leave the car.
NOTE: You cannot remove the front panel with it completely open. You
o
must lift the panel 30-45 to remove it.
Re-attaching the Front Panel
To re-attach the front panel, make sure the electrical terminals on the back
of the panel are free of dust and dirt, as debris could cause intermittent
operation or other malfunctions. Position the right side of the panel in place
until correctly engaged, then lightly press the left side of the panel until the
mechanism locks it into place.
Precautions when Handling the Front Panel
• Do not drop the front panel.
o
angle.
• Do not put pressure on the display or control buttons when detaching or
re-installing the front panel.
• Do not touch the contacts on the front panel or on the main unit body. It
may result in poor electrical contact. Remove any dirt or foreign
substances with a clean, dry cloth.
• Do not expose the front panel to high temperatures or direct sunlight.
• Keep all volatile agents (e.g. benzene, thinner, or insecticides) from
touching the front panel
• Do not attempt to disassemble the front panel.
7