SATA adam X Quick Start Manual

adam X
Quick Start Guide
Assembly
The adam X digital pressure measuring unit can be quickly mounted on the jet X spray gun
without a tool: Attach the device to the Quick Adam Connector (QAC) on the spray gun at an
angle of approx. 90 degrees, then turn it upright until it locks into its end position.
Activation
The adam X is set to shipping mode ex-factory to ensure highest possible battery
charge levels when put into operation the first time.
To activate, connect the jet X - with the adam X attached - to compressed air (≥ 2.0
bar / 29 psi). After a maximum of 30 seconds, the adam X will be booted ready for
use.
Activation is only once required prior to first use!
Operation
The adam X pressure measurement unit is operated with double-tapping actions.
Gently tap the adam X twice on the side to switch to the next screen.
Menu structure
The menu structure of the adam X is split into two levels: The main level and the
settings level. Additonally, a page indicator will tell you which page of the respective
menu is currently activated on the screen.
Pressure (bar/psi) Temperature
Main screen (C°/F°)
Pressure Temperature
measuring unit measuring unit
Operating hours Battery status
(h)
Reset Software version
Transportation
mode
SATA GmbH & Co. KG · Domertalstr. 20 · 70806 Kornwestheim
(%)