Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dogtra 2600T
Summary of Contents for Dogtra 2600T
- Page 2 Si l’unité ne fonctionne pas correctement, se référer au “Guide de Dépannage” de la notice d’utilisation et appeler le Service Après-vente au +33 (0)1 30 62 65 65 avant de retourner l’appareil à Dogtra-Europe pour une réparation. Les frais de transport pour renvoyer des produits 2600T&B...
-
Page 3: Product Safety And Health Statements
Dogtra-Europe does he/she is out of sight or on point. not assume any liability for improper use of the Dogtra The 2600T&B Series is also a training collar that can be e-collar. used for behavior management. -
Page 4: Table Of Contents
It will MAIN FEATURES ............. reactivate when the button is released. OVERVIEW ............... UNDERSTANDING YOUR TRAINING SYSTEM TURNING THE 2600T&B ON/OFF ....... TRANSMITTER BUTTON FUNCTION ....BEEPER SOUND ............BEEPER VOLUME ADJUSTMENT ....... COLLAR FITTING ............. -
Page 5: At A Glance
Dogtra’s auto chargers are designed for use with a 12 volt car outlet. US Charger Dogtra’s US chargers are designed for use with a 110 volt AC electrical outlet. To purchase accessories, please visit www.dogtra-europe. com, call customer service at +33 (0) 130 62 65 65 or... -
Page 6: Main Features
MAIN FEATURES • One-charging system allows the transmitter and receiver(s) to be charged at the same time • Easy-to-use, ergonomically fitted transmitter • Over 8000 different identity codes to prevent signal • Rheostat Dial that allows for gradual adjustments in match-up with other e-collars stimulation intensity with no jumps between levels •... -
Page 7: Overview
Rubber Plug Dog Collar Toggle Switch Locate On/Off Nick Switch & Mode Pager Constant Belt Clip Screen LED Indicator Light On/Off Magnetic Switch On/Off Magnetic (Red Dot) Red Dot Battery Charging Receptacle & Rubber Plug 2600T&B, 2602T&B 2600T&B, 2602T&B Transmitter Receiver/Collar... -
Page 8: Understanding Your Training System
Hold the two red dots together for a 1. TURNING THE 2600T&B ON/OFF moment until the LED light on the receiver/collar comes To turn the handheld transmitter on, hold down the on. -
Page 9: Transmitter Button Function
+33 Mode (0) 130 62 65 65. The transmitter for the 2600T&B Series has five buttons Pager Button (two on the face of the transmitter, two on the left side, The Pager button is located on the left side of the and one on the right side) and a toggle switch. -
Page 10: Beeper Sound
The second time you push the Mode button, it will beep once and remain silent The 2600T&B series is expandable, it can be used with while the dog is running and beep every 2 seconds when one or two collars. -
Page 11: Beeper Volume Adjustment
If the collar is +33 (0) 130 62 65 65. too loose, the contact will not be consistent and cause the corrections to be inconsistent. Dogtra uses surgical Toggle Switch Toggle Switch High LCD Displays... -
Page 12: Finding The Right Stimulation Intensity Selection
SELECTION use your transmitter, the transmitter range may vary. The 2600T&B Series has a Rheostat Dial on the top of To get the greatest range, hold the transmitter away the transmitter (0 is the lowest and 127 is the highest). -
Page 13: Led Indicator
Note: Only use Dogtra-approved lithium polymer amber, or red based on the remaining battery life), as battery chargers for your Dogtra e-collar. This will long as you hold the button down, for up to 12 seconds. prevent any damage that can be incurred from When the Nick button is pushed, the light comes on for attempting to use a different charger. -
Page 14: Charging The Battery
Battery Charging Procedure Note: The unit has a partial charge when it leaves the Dogtra facility. Upon receipt of the collar, be sure to give it a full 2-hour initial charge before the first use. 1. Attach the charging cables to both the transmitter and receiver(s), as shown on page 64. -
Page 15: Handheld Transmitter Lcd
12. HANDHELD TRANSMITTER LCD Care for LCD Transmitters in Cold Temperature In cold temperatures ( - 10° C or below), the Liquid Crystal Display (LCD) on your transmitter may be dim or slow to respond. Wait until the display becomes visible before selecting any training level. -
Page 16: Attaching The Belt Clip
13. ATTACHING THE BELT CLIP 14. USING THE TEST LIGHT 1. To turn on the receiver/collar, place the red dot on the back of the transmitter to the red dot on the receiver/ collar. Hold the two red dots together for a moment until the LED light on the receiver/collar comes on. - Page 17 If you wish to change the tone setting of a collar, press the Locate button once with the horn portion please contact us: info@dogtra-europe.com or by phone: facing away from you (or place your hand over +33 (0) 130 62 65 65.
-
Page 18: General Training Tips
Getting Started With Your 2600T&B Your dog must know some basic obedience commands volume. before beginning training with the 2600T&B. A dog Note 4: In the Run/Point or Point-Only mode, it is still learns by first being shown a command, followed by possible to use vibration and electrical stimulation. -
Page 19: Maintenance
When these Storage Maintenance training procedures are complete, the e-collar is used The 2600T&B should be fully charged before storing for as a reminder when the dog does not comply with your extended periods. While in storage, the unit should be commands at home or in the field. -
Page 20: Troubleshooting Guide
+33 (0) - The range indicated on the unit’s box is for flat 130 62 65 65 or email us at info@dogtra-europe.com. terrain. Heavy brush, trees, hills, or moisture will If you are already using the longest contact points affect the range of your unit. -
Page 21: Warranty And Repair Information
CLiQ are not covered by Warranty. * The cost of shipping products under warranty back to Dogtra-Europe is charging port with clean water. the customer’s responsibility. Dogtra-Europe will provide/pay (via regular - For Dogtra units over two years old from the ground service) the shipping cost back to the customer. -
Page 22: Eu Declaration Of Conformity
Name/Position : H.K. YANG / CEO La Verrière, 26/03/2018 4, Rue de Panicalé 78320 La Verrière, France New address from 1st May 2018 12-14 Rue Augustin Fresnel,78310 Coignières, France T. + 33 (0)1 30 62 65 65 E. info@dogtra-europe.com W. www.dogtra-europe.com...
Need help?
Do you have a question about the 2600T and is the answer not in the manual?
Questions and answers