Simfer SR-2515 Instruction Manual page 33

CLEANING AND MAINTENANCE
Defrosting
• Power off the refrigerator.remove the food from the refrigerator and place it
properly to prevent food from melting.
• Clear the drain pipe (to use soft materials to prevent damage to the liner), Prepare
the water containers for defrosting. (pay attention to clean the compressor
compartment water draining tray, Ovoding overflow to the ground).
• You can also use the appropriate amount of hot water to speed up the defrost, with
a dry towel to dry the water after defrosting.
• You can also use the appropriate amount of hot water to speed up the defrost, with
a dry towel to dry the water after defrosting.
• After defrosting, put back the foods in cabinet, and power on the refrigerator.
Cleaning of door tray
• According to the direction arrow in the figure,
use both hands to squeeze the tray, and push it
upward, then you can take it out.
• After cleaning the door tray, place the tray into
the slot on the door and press down until it is in
place. On some model products you can adjust its
installing height.
Cleaning of glass shelf
• As the innermost part of the refrigerator liner
where contacting the shelves has a backstop, you
shall slightly lift up the rear side of the shelf, then
to take it out.
• After cleaning the glass shelve, place the shelve
horizontally on the rails and push inwards until the
backstop into the slot. On some model products
you can adjust its installing height.
Cleaning the drawer
• Remove the contents of the drawer. Hold the
handle of the drawer and pull it out completely
until it stops.
• Lift the drawer up and remove it out.
33