Dell STREAK 7 User Manual page 141

If the device cannot power on due to system corruption, take either of
these recovery actions:
Reset your device to the default state
Press and hold the power button
1
option on the screen to turn off the device.
Press and hold the volume up button
2
Without releasing the volume up button, press and hold the power button
3
, until the device turns on the configuration screen.
Press the volume up button
4
move the highlight bar on the screen to the Factory Reset option.
Press the power button
5
Wait for the device to reboot.
6
Start software recovery
Connect an SD card to your computer.
1
On your computer, go to support.dell.com and follow the instructions to
2
download the software upgrade package to the SD card.
NOTE:
The device only recognizes the software upgrade package as
"Update.pkg". Rename the downloaded package to "Update.pkg" if it is
not named so.
Disconnect the SD card from the computer and install the SD card into the
3
device.
Follow steps 1 to 3 in Reset your device to the default state to turn on the
4
configuration screen.
Press the volume up button
5
move the highlight bar to the Software upgrade via Update.pkg on SD
card option, and press the power button
Press the power button
6
Wait for the device to load files and reboot the system.
7
and then touch the Power off
.
or the volume down button
to start the reset process.
or the volume down button
to confirm and start software recovery.
to confirm your selection.
Troubleshooting
to
to
141